Panasonic DMR-E500HS Operating Instructions Manual

Also see for DMR-E500HS: Firmware instructions Operating instructions

Contents

Panasonic DMR-E500HS Operating Instructions Manual Manual pdf 9 page image

9RQT7394Getting startedEnjoy multi-channel surround sound on DVD by connecting an amplifier and speakers. There are two types of connection, digital and analog.∫ Analog connection ∫ Digital connectionUse one of the following connections to suit the antenna lead.≥If your television has both lead and coaxial VHF terminals, usethe lead connection to minimize signal loss.∫ A single twin lead∫ A twin lead and a coaxial cable∫ Two twin leadsUse one of the following connections to suit the antenna terminalson your television. Refer to the television’s operating instructions.∫ A twin lead and coaxial plug terminal∫ A twin lead terminal∫ Two twin lead terminals∫ Multiple antenna terminals≥Connect to one of the ANT terminals, then change the television’ssettings as necessary.Connecting an amplifier or system componentIf the antenna connector doesn’t matchY PB PRR - AUDIO - L VIDEO S-VIDEOOPTICALG-LINK COMPONENTVIDEO OUT(480p/480i) DIGITAL AUDIO OUT(PCM/BITSTREAM)IN1 (L1) IN3 (L3)R - AUDIO - L VIDEO S-VIDEOOUT1 OUT2VHF/UHFRF INRF OUTSUB WOOFER CENTER R LFRONTAUDIO OUTjLAN (10/100) 5.1chR - SURROUND - LOPTICAL INFRONTR LSURROUNDR LCENTERSUB-WOOFEROptical digital audiocableDo not bend sharplywhen connecting.Insert fully, with thisside facing up.Audio cableThis unitRed WhiteRed WhiteTo enjoy multi-channel surround sound on DVD-Video connect an amplifier with a built-in decoderdisplaying these logo marks. Use an optical digitalaudio cable and change the settings in “Digital AudioOutput” (➡ page 63).≥You cannot use DTS Digital Surround decoders notsuited to DVD.≥Even if using this connection, output will only be from 2 channelswhen playing DVD-Audio.Amplifier’s rear panelAmplifier’s rear panelTo AUDIO OUT 5.1 chTo enjoy multi-channel surround sound on DVD-Video andDVD-Audio connect an amplifier using the AUDIO OUT 5.1 chterminals and go to the settings on page 15.≥Switch the attenuator on if sound is distorted with thisconnection (➡ page 63).orConnect with AUDIO OUT1 or 2 terminals to enjoystereo (2 channel) sound.Other antenna connections to the unit300–75 ≠ transformerfrom the antenna(Flat) Twin lead300 ≠ cable To this unit’s RF INterminalfrom the antenna(Flat) Twin lead 300 ≠ cableTo this unit’s RF INterminal(Round)75 ≠ coaxial cableVHF/UHF band mixerfrom the antennaTo this unit’s RFIN terminal300–75 ≠ transformer(Flat) Twin lead300 ≠ cableVHF/UHF band mixerOther antenna connections from the unit to thetelevisionVHF/UHF band separatorTelevision75 ≠ coaxial cableVHFUHF75 ≠ coaxial cable75–300 ≠ transformerTelevisionVHF orUHF75 ≠ coaxial cableVHF/UHF band separatorTelevisionVHFUHFANT 2ANT 1Split out Television75 ≠ coaxial cable