7RQT7444Getting started∫ Component video outputComponent signal outputs the colour difference signals (P B/P R ) and luminance signal (Y) separately in order to achieve high fidelity inreproducing colours. If the television is compatible with progressive output, a high quality picture can be output because this unit’s componentvideo output terminal outputs a progressive output signal (➡page 42).For progressive output (➡page 10)∫ Connecting to a television with 21-pin ScartterminalYou can also connect with the AV1 terminal on this unit using the21-pin Scart cable.If your television is equipped with RGB input capability, byconnecting with a fully wired 21-pin Scart cable you can see videousing RGB output on this unit.To output in RGB select “RGB (without component)” from “AV1Output” in the SETUP menu (➡page 37).RGB refers to the three primary colours of light, red (R), green (G),and blue (B) and also the method of producing video that usesthem. By dividing the video signal into the three colours fortransmission, noise is reduced for even higher quality images.∫ Connecting to a VCR with 21-pin Scart terminalYou can also connect with the AV2 terminal on this unit using the21-pin Scart cable.To input in RGB select “RGB (Not NTSC)” from “AV2 Input” inthe SETUP menu (➡page 37).Connecting a television with AUDIO/VIDEO, S-VIDEO or COMPONENT VIDEOterminals and VCRR - AUDIO - L VIDEOP RS-VIDEOR - AUDIO - L VIDEO S-VIDEOOPTICALOUT AV4 INRF INRF OUTDIGITAL AUDIO OUT(PCM/BITSTREAM)COMPONENTVIDEO OUT(NTSC:480P/480I,PAL:576P/576I)PBYAV1 (TV)AV2 (DECODER/EXT)AC INVHF/UHFRF INCOMPONENTVIDEO INS-VIDEO INVHF/UHFRF INAUDIO INR L VIDEO INR LAUDIO OUT VIDEO OUT2 131 44To the aerialSplitterVideo cableAerialcableCooling fanRF coaxial cableAC mains leadConnect only after all otherconnections are complete.This unit’s rear panelAudio/Video cableTo household mains socket(AC 220–240 V, 50 Hz)S-VideocableAudio/Video cableRed White YellowRed White YellowRed White YellowRed White YellowWhen making this connection, ensure youconnect the audio cables to the correspondingaudio input terminals on the television.indicates included accessories.indicates accessories not included.are required connections. Connect in the numbered order.Television’srear panelVCR’s rear panelS-VIDEO OUT terminalThe S-VIDEO OUT terminal achieves a morevivid picture than the VIDEO OUT terminal.(Actual results depend on the television.)COMPONENT VIDEO OUT terminalThese terminals can be used for either interlace orprogressive output and provide a purer picture than theS-VIDEO OUT terminal (➡ below).≥Connect to terminals of the same colour.Use a splitter ifyou also wantto connect theaerial to yourVCR.