Panasonic DMR-EX75EG Service Manual

Also see for Diga DMR-EX75EB: Operating instructions Quick setup guide

* Note 3:Please prepare latest firmware updating disc.*Main Firm is being recorded in HDD, but new HDD has no data.CAUTION:· Writing of Main Firm needs 3, 4 minutes.· Never cut the power of DVD Recorder until writing in Firmware ends.· Initial settings and contents of reservation will not change if writing is normally completed.Writing Procedure of Main Film:1. Prepare updating disc for firm ware2. Replace HDD3. Turn on power of DVD Recorder4. After [PLEASE WAIT] is displayed on FL., [HDD ERR] is displayed on FL5. Tray opens automatically6. Insert updating disc for Firmware and press OPEN / CLOSE key(If a wrong disc was insered, [NG DISK] [NO FVU] is displayed on FL.)7. [LOAD] → [LD FVU] ←→ [M_FIRM] are displayed on FL alternately8. [MAIN] ←→ [UPD OK] blink alternately and Tray opens. Take out disc (Writing was finished)9. Press Power button to turn off power10. Press Power button to turn on power11. [HELLO] → [SELF CHECK] are displayed on FL12. [UNFORMATED] is displayed on FL13. After [UNFORMAT] was displayed, message to request FORMAT is displayed on TV screen14. Select [Yes] and press [ENTER] key to format HDD(After FORMAT, program in HDD will be lost, but Main firm will not be lost“Write of the main farm” is completed above* Drive firm is not updated by above operation. If you wish update Drive firm, please prepare the disc for latest firmware update,and write again.* If the version of the firm you have prepared was same as or later than has already been written in deck, “UNSUPPORT” isdisplayed on FL.* In a usual updating of firmware, writing is not performed when the timer reservation standby was not released.11.2.2. NOTICE AFTER REPLACING RAM/DIGITAL P.C.B. MODULEAfter replacing RAM/Digital P.C.B. Module, “TM AV1” is displayed on FL. Once power off, and start-up again.42DMR-EX75EG / DMR-EX75EC / DMR-EX75EB / DMR-EX85EG / DMR-EX85EB