Panasonic DMR-EZ47VP Service Manual

Error Code Diagnosis contents Description Monitor Display Automatic FL displayF09 Serial Communication Errorbetween VHS Microprocessorand Timer Microprocessor.Please confirm Serial Communicationterminal of Microprocessor.NOTE:If F09 appears just after updating Firmware,pull off and insert AC plug, then it willdisappear.No displayF34 Initialization error when mainmicroprocessor is started upfor program recordingWhen initialization error is detected afterstarting up main microprocessor for programrecording, the power is turned offautomatically.The event is saved in memory.No display No displayF58 Drive hardware error When drive unit error is detected, the event issaved in memory.No display No displayF60 DVD module has not beenstarted.Defect of Digital P.C.B.Mode: No changeNo displayHDMI HDMI connection check This unit is confirming that ut is connectedwith equipment compatible with HDAVIcontrol.No displayF74 HDIM Device KeyCommunication error.HDMI connection could not be authenticateddue to a transfer malfunction.Factor of HDMI Device key-road failure· When HDMI LSI is damaged.· When the bus line of I2C doesn´t operatenormally.· When device key information recorded isdamaged.No displayF75 HDIM Device Key InformationerrorHDMI connection could not be authenticateddue to an internal data malfunction.Factor of HDMI Device key-road failure· When HDMI LSI is damaged.· When the bus line of I2C doesn´t operatenormally.· When device key information recorded isdamaged.No displayUNSUPPORTUnsupported disc error *An unsupported format disc was played,although the drive starts normally.*The data format is not supported, althoughthe media type is supported.*Exceptionally in case of the disc is dirty.“This disc isincompatible.”Display for 5 seconds.NO READ Disc read error *A disc is flawed or dirty.*A poor quality failed to start.*The track information could not be read.“Cannot read.Please check thedisc.”HARDERRDrive error The drive detected a hard error. “DVD drive error.” Display for 5 seconds.No REC Recording is impossible [No REC] is displayed when recording isimpossible due to the defect, dirt or wound ofmedia.No displaySELFCHECKRestoration operation Since the power cord fell out during a powerfailure or operation, it is under restorationoperation.*It will OK, if a display disappearsautomatically. If a display does not disappear,there is the possibility that defective DigitalP.C.B.No display“0” is displayed one by one.17DMR-EZ47VP / DMR-EZ475VP