Pre Installation Information109Internet FaxFeaturesTo install your machine as POP3 Client, the following network parameters need to be programmed on yournetwork.• TCP/IP Address of your machine• TCP/IP Subnet Mask of your machine• TCP/IP Address of the Default Gateway• TCP/IP Address of the DNS Server (if not available, see Note 2)• Email Address of your machine (see Note 1)• Name or IP Address of the Default SMTP mail server• POP Server Name or IP Address• POP User Account Name• POP PasswordEmail Transmission (from your machine to a PC)Email reception (from a PC to your machine)NOTE 1. The email address format can be the same as your regular email address. If your emailaddress is popuser001@panasonic.com, your machine's email address can beInternet_Fax@panasonic.com.2. By default the machine requires the IP Address of the DNS Server and prompts you to enterthe SMTP and POP Server Names.If the DNS Server is not available, change the 27(DNS Server Address)(For DP-2330/3030),26(DNS Server Address)(For DP-3530/4530/6030) of General Settings to "No" .(For DP-2330/3030)Press , Input ID Code,.(For DP-3530/4530/6030)Press , Input ID Code,.Then the machine will prompt you to enter the IP Address of the SMTP and POP Servers.Setup as POP3 Clientifaxuser@fax01.panasonic.comSMTP01.panasonic.com(SMTP Mail Server)POP02.panasonic.com(POP Server)Gateway(Router)popuser001@panasonic.comSMTPPOP3ifaxuser@panasonic.comSMTP01.panasonic.com(SMTP Mail Server)POP02.panasonic.com(POP Server)Gateway(Router)popuser001@panasonic.comSMTPPOP3FUNCTION GENERAL SETTINGS 09 Key Operator ModeOK 27 DNS Server AddressFUNCTION GENERAL SETTINGS 04 Key Operator ModeOK 26 DNS Server Address