Troubleshooting209Problem SolvingWhen something unusual occurs, the display may show one of the Information Codes listed below. Thesewill help you to identify and correct the problem.Information CodesInfo.Code Meaning Possible Action Page030 Document is misfeeding. 1. Reload the document properly.2. Remove the document jam.3. Adjust ADF.17031 Document is too long or jammed.Document length exceeds 78.8 inches (2 meters) in"Normal" and "Fine" mode only. The length limitationfor "Super Fine" and "600 dpi" mode, is subject to theavailable Memory size.Super Fine 600dpi(Max. Length) (Max. Length)A4/Letter Width: 55 in (1400 mm) 24 in (600 mm)A3/Ledger Width : 39 in (990 mm) 17 in (430 mm)1. Reload the document properly.2. Remove the document jam.3. Add additional Flash Memory.17061 ADF Door (Document Return Guide) is open. Close the ADF Door. --400 During initial handshake, receiving station did notrespond or communication error occurred.1. Check with the other party.2. Reload the document and send again.--401 Remote station required a Receiving Password toreceive the document.Remote station does not have Confidential Mailbox.Check the remote station. --402 During initial handshake, communication erroroccurred.Reload the document and send again. --403 No polling capability at the remote side. Ask remote side to set "POLLED=ON". --404/405 During initial handshake, communication erroroccurred.Reload the document and send again. --406 Transmission Password does not match.Receiving Password does not match.Received from an unauthorized station in SelectiveReception mode.Check the password or the telephone numberin Address Book.7792407 No confirmation from the receiving station for theprevious page sent.Wait a few minutes and send again. --408/409 Remote side confirmation of previous page is illegible. Wait a few minutes and send again. --410 Communication aborted by the transmitting side. Check with the other party. --411 Polling password does not match. Check the polling password. 46412 No data from the transmitting side. Check with the other party. --414 Polling password does not match. Check the polling password. 46415 Polling transmission error. Check the polling password. 46416/417/418/419Received data has too many errors. Check with the other party. --420/421 Machine goes to receiving mode, but receives nocommand from the transmitting side.1. Remote side misdial.2. Check with the other party.--422/427 Interface is incompatible. Check with the other party. --430/434 Communication error occurred while receiving. Check with the other party. --436/490 Received data has too many errors. Check with the other party. --Continued on the next page...
