Panasonic DVD-A7 Operating Instructions Manual

Also see for DVD-A7: Operating instructions Operating instructions Service manual

mi Adding an amplifier and speakers to your system - Connectionand settingsUse the following chart when you wish to add an amplifier and speakers to your system. Further informationis q iven on the following pages.Connectlon*l Digital output eetUng Speaker setting(=F Page 38) (,,k Page 40)You want to enjoy the 5.1-channel • An amplifier with 5.1-channel • Set PCM Down • Set all speakers to onsurround sound recorded on DVDs input terminals Conversion to "No" (Large. Small or Yes).using the unit's built-in decoder. •A 5.1-channel speaker • Correct output balancesystem • Set delay time(,_ Page 35)You want to enjoy the 5.1-channel =A decoder • Set PCM Down • No settings requiredsurround sound recorded on DVDs =An amplifier with 5.1 -channel Conversion to "Yes" • Make speaker settings onusing the decoder in another unit input terminals • Set Oolby Digital and DTS the decoder.(e.g., a dlgital sound processor), eA 51-channel speaker Digital Surround tosystem "Bitstream"*2(..I. Page 36)You want to connect a 2-channel =A 2-channel analog amplifier • Set PCM Down • No settings requiredanalog amplifier (including Dolby Pro (mS.Page 37) Conversion to "No" • Some settings are requiredLogic amplifiers), on Dolby Pro Logic amplifiersYou want to connect a 2-channel • A 2-channel digital amplifier • Set PCM Down • No settings requireddigital amplifier. (=_ Page 37) Conversion to "Yes"=Set Dolby Digita! and DTSDigital Surround to "PCM"You want to record onto a cassette • A cassette deck =Set PCM Down • No settings requireddeck or other analog recording • An amplifier Conversion to "No"device. P (=) Page 37)You want to record onto an MD deck • An MD deck =Set PCM Down • No settings requiredor other digital recording device.*3 ('_ Page 37) Conversion to "Yes"=Set Dolby Digdal and DTSDigital Surround to "PCM"You want to connect 3 speakers. • An amplifier with 5.1-channel • Set PCM Down • Set center to on (Large orinput terminals Conversion to "No" Small).• Your speakers, two front and • Set surround to "No".one center. =Correct output balance(_ Page 35) • Set delay timeYou want to connect 4 speakers. • An amplifier with 5.1-channel • Set PCM Down • Set surround to on (Large orinput terminals Conversion to "No" Small).• Your speakers, two front and • Set center to "No",two surround. • Correct output balance(_" Page 35) • Set delay time• 1 Equipment listed are examples.• 2 If your decoder is not able to handle DTS signals, set Colby Digital to "Bitstream" and DTS Digital Surround to "PCM".• 3 Connect digital equipment that is able to handle a 48 kHz/16 bit sampling rate. You cannot record digitally if there is a copy guard on the disc.Turn V.S.S. (=_ page 16) off when you connect more than just the two front speakers. Sound wtll not be output from the o her speakers if V.S.S.iS on,vQ'rgg54