Panasonic Diga DMR-EH50 Operating Instructions Manual

Also see for Diga DMR-EH50: Operating instructions Quick setup guide Operating instructions Operating instructions Operating instructions

Contents

19RQT8023Getting startedYou can configure the remote control TV operation buttons to turnthe television on/off, change the television input mode, select thetelevision channel and change the television volume.1 Point the remote control at the televisionWhile pressing [Í POWER TV] enterthe code with the numbered buttons.e.g., 01: [0] ➡ [1] 10: [1] ➡ [0]Manufacturer and Code No.2 Test by turning on the television andchanging channels.≥Repeat the procedure until you find the code that allowscorrect operation.≥If your television brand is not listed or if the code listed foryour television does not allow control of your television, thisremote control is not compatible with your television.[Note]≥If your television brand has more than one code listed, select theone that allows correct operation.Change the remote control code on the main unit and the remotecontrol (the two must match) if you place other Panasonic productsclose together.Use “1”, the factory set code, under normal circumstances.1 Press [SETUP].2 Press [3, 4] to select “Setup” andpress [1].3 Press [3, 4] to select “RemoteControl Code” and press [ENTER].4 Press [3, 4] to select the code (1, 2,or 3) and press [ENTER].5 To change the code on the remote controlWhile pressing [ENTER], press andhold the numbered button ([1], [2] or[3]) for more than 2 seconds.6 Press [ENTER].∫ When the following indicator appears on theunit’s display and you are unable to operate theunitChange the code on the remote control to match the main unit’s(➡ step 5).To return to the previous screenPress [RETURN].To exit the screenPress [SETUP].Television operationPanasonicNationalQUASAR01/02PHILIPS (RC-5) 03RCA 05SAMSUNG 14/18/19FISHER 10 SANYO 10GE 05 SHARP 06/07GOLDSTAR 15/16/17 SONY 08HITACHI 12 SYLVANIA 03JVC 11 THOMSON 05LG 15/16/17 TOSHIBA 09MAGNAVOX 03 ZENITH 04MITSUBISHI 13When other Panasonic productsrespond to this remote controlSETUP Remote Control CodePress “±” and “ENTER” togetherfor more than 2 seconds on the remote.DiscChannelSetupThe unit’s remote control code