Panasonic Diga DMR-EH50 Operating Instructions Manual

Also see for Diga DMR-EH50: Operating instructions Quick setup guide Operating instructions Operating instructions Operating instructions

Contents

57RQT8023ConvenientfunctionsChannel/Clock settings when TV Guide On Screen TM system is not usedRefer to the control reference on page 54.Preparation:If the television program list has already been downloaded, return the unit to the factory preset condition using the steps indicated below.When the unit is on and stopped1 Press and hold [X CH] and [W CH] on the main unit for about fiveseconds.The unit turns off.2 Press [Í DVD POWER] to turn the unit on.3 Complete the TV Guide On ScreenTM system setup (until [ENTER]is pressed after the “Watch TV” message screen is displayed).[Note]You can set scheduled recording only manually after you set the unit with “Set Channels Automatically”.1 Press [SETUP].2 Press [3, 4] to select “Channel” andpress [1].3 Press [3, 4] to select “Set ChannelsAutomatically” and press [ENTER].4 Press [2, 1] to select “Yes” andpress [ENTER].5 Press [ENTER].Auto Channel Setting starts. This takes a few minutes.The unit then proceeds with Auto Clock Setting. The time isdisplayed when finished.≥DST, Daylight Saving Time, shows the summertime setting.≥TIME ZONE shows the time difference from GreenwichMean Time (GMT).EST (Eastern Standard Time) l GMT j5CST (Central Standard Time) l GMT j6MST (Mountain Standard Time) l GMT j7PST (Pacific Standard Time) l GMT j8AST (Alaska Standard Time) l GMT j9HST (Hawaii Standard Time) l GMT j10For other areas: xx hr≥If the Auto Clock Setting does not start automatically, select“Clock Settings” from the “Setup” tab and then select “SetClock Automatically”.≥If the time was not set correctly, use manual clock setting(➡ 17) or adjust time zone.6 Press [ENTER].≥The unit configures channels according to the Signal Source(RF IN) settings as follows.Adjust the time zone (j1 or i1) if it was not set correctly with autoclock setting.You cannot change this setting if you set the clock manually.1 Press [SETUP].2 Press [3, 4] to select “Setup” andpress [1].3 Press [3, 4] to select “ClockSettings” and press [ENTER].4 Press [3, 4] to select “Adjust TimeZone” and press [ENTER].5 Press [3, 4] to select “s1” or “r1”and press [ENTER].To return to the previous screenPress [RETURN].To exit the screenPress [SETUP].To cancel partway while Auto Channel/Clock Setting is taking placePress [RETURN].I N 2I N 2C HC HHDD DVD SDS VIDEOS VIDEO VIDEOVIDEO L/MONOL/MONO -AUDIOAUDIO -ROPEN/CLOSEOPEN/CLOSE D R ID R I V EV ES E L E C TS E L E C T R E CR E C/x1.3X CH WAuto channel/clock settingsChannelSETUPSetupDiscVideoAudioSet Clock AutomaticallyAuto Clock Setting is complete.4/4/2005 12:15 AMDST.............. OnTime Zone..... CSTSignal Source(RF IN)Band ChannelAntenna VHF 2–13UHF 14–69CableTVVHF 2–13CATV LOW BAND 95–99CATV MID/SUPER BAND 14–36CATV HYPER BAND 37–65ULTRA BAND 66–94100–125SPECIAL CATV CHANNEL 1Adjust Time ZoneSETUPSetupDiscVideoAdjust Time Zonej10i1Channel