Panasonic Diga DMR-EH50 Operating Instructions Manual

Also see for Diga DMR-EH50: Operating instructions Quick setup guide Operating instructions Operating instructions Operating instructions

Contents

YoucanconfiguretheremotecontrolTVoperationbuttonstoturnthetelevisionon/off,changethetelevisioninputmode,selectthetelevisionchannelandchangethetelevisionvolume.Point the remote control at the televisionWhile pressing [_ TV], enter thecode with the numbered buttons.e.g., 01: [0] = [1] 10: [1] = [0]Manufacturer and Code No.PanasonicAKAIBRANDTCURTISDUALFERGUSONGOODMANSHITACHIIRRADIOJVCMETZMIVAR201/02/03/04/4527/3010/153105/061005/06/31NOKIA 25/26/27ORION 37i PHONOLA 31/33PYE 05/06SABA 10SAMSUNG 31/32/43SANYO 2122/23/31/40/41/423017/3928/3124SCHNEIDER 05/06/29/30/31SHARP 18SINUDYNE 05/06/33TELEFUNKEN 10/11/12/13/14TOSHIBA 16_i_Test by turning on the television andchanging channels.• Repeat the procedure until you find the code that allowscorrect operation.• If your television brand is not listed or if the code listed foryour television does not allow control of your television, thisremote control is not compatible with your television.=If your television brand has more than one code listed, select theone that allows correct operation.Change the remote control code on the main unit and the remotecontrol (the two must match) if you place other Panasonic productsclose together.Use "DVD 1", the factory set code, under normal circumstances.While stoppedPress [FUNCTIONS].2 Press [&, ,] to select "To Others"and press [ENTER].3 Press [&, T] to select "SETUP" andpress [ENTER].4 Press [&, T] to select "Others" andpress [1_].5 Press [&, T] to select "RemoteControl" and press [ENTER].6 Press [&, T] to select the code("DVD 1", "DVD 2" or "DVD 3") andpress [ENTER].78To change the code on the remote controlWhile pressing [ENTER], press andhold the numbered button ([1], [2] or[3]) for more than 2 seconds.Press [ENTER].• When the following indicator appears on theunit's displayThe unit's remotecontrol codeChange the code on the remote control to match the main unit's(= step 7).Executing "Shipping Condition" in the SETUP menu returns themain unit code to "DVD 1". Change the remote control code to 1(= step 7).To return to the previous screenPress [RETURN].To exit the screenPress [RETURN] several times.