Panasonic Diga DMR-ES35 Operating Instructions Manual

Also see for Diga DMR-ES35V: Operating instructions Operating instructions Setup guide Setup guide Instrucciones de funcionamiento

Contents

59RQTV0134MessagesOn the unit’s display PageOn the TV PageH, F(“” stands for a number.)≥An error has occurred. The number following “H” or “F” depends on the status of the unit. Check theitems in the “Error messages” section and the “Troubleshooting guide”. If the service number stilldoes not disappear after the check, follow the Reset procedure described below.Reset procedure: (“The unit is on but cannot be operated.” l 62)≥If the service numbers fail to clear, note the service numbers and contact a qualified service person.––SET (“” stands for a number.)≥The remote control and main unit are using different codes. Change the code on the remote control. 19HARD ERR ≥If there is no change after turning the unit on and off, consult the dealer where the unit waspurchased.–NoREAD ≥The disc is dirty or badly scratched. The unit cannot record, play, or edit.≥You have used a lens cleaner and it has finished. Press [<, OPEN/CLOSE] to eject the disc.6, 922PLEASE WAIT(“PLEASE” and “WAIT” arealternately displayed.)≥Displayed when the unit is started. This is not a malfunction.≥The unit is carrying out its recovery process. You cannot operate the unit while “PLEASE WAIT” isdisplayed.––PROG FULL(“PROG” and “FULL” arealternately displayed.)≥There are already 16 scheduled recording programs. Delete unnecessary scheduled recordingprograms.29UNSUPPORT(“UNSUP” and “PORT” arealternately displayed.)≥You have inserted a disc the unit cannot play or record on. 7UNFORMAT(“UNFOR” and “MAT” arealternately displayed.)≥You have inserted a new DVD-RW/+R/+R DL/+RW or a DVD-RAM/DVD-RW (DVD-Video format)recorded on other equipment.54U59 ≥The unit is very warm.The unit switches to standby for safety reasons. Wait for about 30 minutes until the messagedisappears.Select a position with good ventilation when installing the unit. Do not block the cooling fan on therear of the unit.–U61 ≥There was a power failure or the AC plug was disconnected while the unit was on. The unit iscarrying out its recovery process. This process restores the unit to normal operation. The unit is notbroken. Wait until the message disappears.–U88 ≥There was something unusual detected with the disc while recording, playing or transferring(copying), there was a power failure or the AC plug was disconnected while the unit was on. The unitis carrying out its recovery process. This process restores the unit to normal operation. The unit is notbroken. Wait until the message disappears.61U99 ≥The unit fails to operate properly. Press [Í/I, POWER] on the main unit to switch the unit to standby.Now press [Í/I, POWER] on the main unit again to turn the unit on.–Cannot finish recordingcompletely.≥The program was copy-protected.≥The disc may be full.≥There are already 99 recorded titles ([+R] [+R]DL] [+RW] 49 recorded titles).–––Cannot play. ≥You inserted an incompatible disc (Discs recorded in PAL video, etc.). –Cannot record on the disc. ≥The disc may be dirty or scratched. 9Unable to format.Please check the disc.Cannot record. Disc is full. ≥Create space by erasing any unwanted titles. [RAM] [-RW‹V›] [+RW][Even if you erase recorded content from the DVD-R or +R, there is no increase in disc space. Availablerecording space on a DVD-RW (DVD-Video format) or +RW increases when the last recorded title isdeleted. (The recording space may increase slightly when other titles are deleted.)]≥Use a new disc.38, 52,53–Cannot record. The numberof titles has exceeded themaximum limit.Error has occurred. Pleasepress ENTER.≥Press [ENTER] to start recovery process. You cannot operate the unit while it is recovering(“SELF CHECK” appears on the unit’s display).–No disc ≥You haven’t inserted a disc. Correctly insert a disc that the unit can play.≥The disc is upside down. If it is a single-sided disc, insert it so the label is facing up.6, 9, 2222No VHS cassette ≥A video cassette is not inserted when recording programs. Insert a video cassette with an accidentalerasure prevention tab.10, 22Now recording on DVD.To watch the VHS playback,connect a TV to DVD/VHSCOMMON OUT terminal at theback of the unit, and select theappropriate input on the TV.≥The VHS plays back while recording on DVD. You can watch the VHS playback by connect to theDVD/VHS COMMON terminals.14Please change the disc. ≥There may be a problem with the disc. Press [<, OPEN/CLOSE] on the main unit to remove it andcheck it for scratches or dirt. (The unit turns off automatically after you open the tray.)9Please set the clock. ≥The clock is not set when recording programs or setting the scheduled recording. Set the clock. 17, 20The VHS cassette isprotected.≥A video cassette without the accidental erasure prevention tab is inserted when recording programs.Use a video cassette with an accidental erasure prevention tab.10This is a non-recordable disc. ≥The unit cannot record on the disc you inserted. Insert a DVD-RAM or unfinalized DVD-R,DVD-R DL, DVD-RW (DVD-Video format), +R, +R DL or +RW.≥You inserted an unformatted DVD-RAM, DVD-RW, +R, +R DL or +RW. Format the disc with the unit.–54This disc is not formattedproperly.≥The operation is prohibited by the unit, disc or cassette. 30Changing the unit’s settings/Messages