Panasonic Diga DMR-ES35 Operating Instructions Manual

Also see for Diga DMR-ES35V: Operating instructions Operating instructions Setup guide Setup guide Instrucciones de funcionamiento

Contents

62RQTV0134Troubleshooting guideOperation PageCannot operate the TV. ≥Change manufacturer code. Some TVs cannot be operated even if you change the code.≥Press [TV/VIDEO] to change the input mode to “TV”.1926Cannot operate the DVD. ≥Press [DRIVE SELECT] to select DVD drive when operating DVD. 11Cannot operate the VHS. ≥Press [DRIVE SELECT] to select VHS drive when operating VHS. 11The remote control doesn’twork.≥The remote control code is wrong. Change to the correct code.≥The batteries are depleted. Replace them with new ones.≥Point the remote control at the remote control sensor on the main unit.≥Remove obstacles between the remote control and main unit.≥Colored glass may abstruct the signal reception/transmission.≥Don’t place the signal sensor in direct sunlight or in areas that may be subject to sunlight exposure.≥It may be necessary to set the code on the remote control again after changing the batteries.≥It may be necessary to set the manufacturer code again after changing the batteries.1999–––99The unit is on but cannot beoperated.≥Some operations are prohibited by the disc.≥The unit is warm (“U59” appears on the unit’s display). Wait until “U59” disappears.≥One of the unit’s safety devices may have been activated.Reset the unit as follows:(1) Press [Í/I, POWER] on the main unit to switch to standby.If the unit doesn’t switch to standby, press and hold [Í/I, POWER] on the main unit for about 10seconds. The unit is forcibly switched to standby.Alternatively, disconnect the AC power supply cord, wait for about 1 minute, then reconnect it.(2) Press [Í/I, POWER] on the main unit to turn the unit on.–––Cannot eject a disc. ≥The unit is recording≥The unit may have a problem. While the unit is off, hold down [∫] and [CH, W] on the main unitsimultaneously for about 5 seconds. Remove the disc and consult the dealer.––Startup is slow ≥Make sure that “Quick Start” is set to “On”.Even if “Quick Start” is set to “On”, startup is slow if the clock is not set, there was a power failure orthe AC plug has just been connected.≥A few dozen seconds after turning on the unit, you can play a disc or start recording to discs otherthan DVD-RAM.56–Takes time to read DVD-RAM ≥It may take time to read a disc if it is being used for the first time in this unit or it has not been usedfor a long time.–