Panasonic Diga DMR-EZ45VEBS Operating Instructions Manual

Also see for Diga DMR-EZ45VEBS: Quick setup guide

Contents

FUNCTIONSSETUPSetupFUNCTIONSDVD VHSL CKOSDSound Setting ENTERENTER OptionDVD-VSetupTuningDiscPictureSoundDisplayConnectionOthersDynamic Range CompressionAudio Mode for XP RecordingBilingual Audio SelectionDigital Audio OutputDolby DigitalOffM1VHS TABSELECTRETURNENTERAudio Mode for DV Input Stereo1SetupTuningDiscPictureSoundDisplayConnectionOthersPCM Down ConversionMPEGDolby DigitalPCMOffBitstreamDigital Audio OutputDTS BitstreamVHS SELECTRETURNENTER BitstreamDolby DigitalPCM-R +R-RW(V) +R DL-R DL +RWTo OthersBilingual Audio SelectionDynamic Range CompressionDigital Audio Output [PCM Down Conversion][Dolby Digital] [DTS] [MPEG][M 1] [M 2]On: The level of quieter passages increases and the level of louder passagesdecreases. The audio can be clearly understood even when the volume is lowered.If you want to record programmes that are broadcast in dual-channel sound, you canselect between the original language [M1] or another available language [M2]. If youare copying from an external source or from a tape position, select the sound track onthe other unit.Select the appropriate setting if you have connected an external unit to theDIGITAL AUDIO OUT of the DVD Recorder.[On] [Off] (Dolby Digital Only)PCM Down Conversion [On] [Off]Select the audio output mode for a scan frequency of 96 kHz or 88.2 kHz. Despite thissetting, signals are converted to 48 kHz or 44.1 kHz if they have a scan frequency over96 kHz or 88.2 kHz or if the disc is copy-protected.On: The connected unit cannot process signals with a scan frequency of 96 kHz or88.2 kHz. Signals are converted with 48 kHz or 44.1 kHz.Off: The connected unit can process signals with a scan frequency of 96 kHz or 88.2kHz. Signals are output as 96 kHz or 88.2 kHz.Dolby Digital, DTS, MPEGAudio Mode for DV Input[Bitstream] [PCM][Stereo 1] [Stereo 2] [Mix]Bitstream: The connected unit can decode the corresponding signal.PCM: If the connected unit cannot decode the corresponding signal, the setting must bechanged to [PCM]. Otherwise, the loud noise can lead to damage to your hearing orloudspeakers. Make the necessary changes depending on your audio system.Select the audio type when copying from the DV input.Stereo 1: Original sound; Stereo 2: Voice-over, Mix: Original sound + voice-overAudio Mode for XP Recording [Dolby Digital] [LPCM]Selection of the audio type when copying in XP mode.The picture quality of LPCM recordings may be worse than with normal recordings in XPmode.-R +R-RW(V) +R DL-R DL +RWDisplay Setting ENTERENTER OptionSetupTuningDiscPictureSoundDisplayConnectionOthersDVB Preferred SubtitlesOn-Screen MessagesGrey BackgroundEnglish5 secOnFL Display BrightVHS TAB SELECTRETURNNew Service Message AutomaticNew Service Message [Automatic][Off]On-Screen MessagesAutomatic: The on-screen displays are displayed on the screen.Grey BackgroundFL DisplayOn: The grey background is displayed when there is no television reception.[Off] [3 sec] [5 sec] [7 sec] [10 sec][On] [Off][Bright] [Dim]DVB Preferred SubtitlesSelect the language of the subtitles.[English] [Welsh] [Gaelic]Dim: The display goes dark during playback. It lights up again when a button ispushed. If the unit is switched off, the display turns off.Off: The Service Messages are not shown.63