Panasonic EB-GD75 Service Manual

Also see for EB-GD75: Operating instructions

Contents

DISASSEMBLY / REASSEMBLY INSTRUCTIONSIssue B Section 4 MCUK011201C8Revision 0 – 20 – Service Manual2. Remove the two case screws located inside the battery compartment.Figure 4.2: Case Screw Removal3. Carefully prise apart the case and cover, creating a gap at the base I/O connector. Insert the Case Separation Tool (seeSection 6) into the gap created, and gently slide the tool in the direction shown, ensuring that the moulded hooks separateall the way up to point ‘A’.Figure 4.3: Case-Cover Separation4. Repeat step 2 for the opposite side of the telephone. Carefully twist the cover so that the hooks at position ‘B’ and thoseat the corresponding position on the opposite side of the phone separate.5. Separate by gently twisting the case and cover.CAUTIONThere is an SAR Shield built into the Handset Cover. When handling the Cover, DO NOT bend or damage the metalspring from the SAR Shield as this must make contact with the groundplane of the PCB.If the spring is damaged, replace the complete Cover Assembly.10504-1AB10505-1