Chapter 14 Automatic Transfer ControllerOperationXIV - 2014-3-11 Transfer Mode 6In transfer mode 6, ATC1 automatically transfers one byte of data two times every time an ATC1 activationrequest occurs.(1)(2) (3)(4)AT1MAP0AT1MAP0 + 1AT1MAP0 + 2AT1MAP0 + 300000 - 3FFFF 03F00 - 03FFF(Only lower8 bits are valid)AT1MAP1Transfer mode 6 can be used to support continuous transmission/reception for serial inter-face 3. Set memory pointer 1 to point to the serial transmission/reception shift register(SCnTRB) and select serial interrupts as an ATC1 trigger factor. In this way, each time aserial communication ends the MCU continuously reads the received data (first data bytetransfer) then writes the transmission data (second data byte transfer) up to 255 times,entirely through the hardware.In this mode the transfer direction indicated by memory pointers 0 and 1 reverses for the second databyte transfer.In the first data byte transfer, the I/O space address (x'03F00' - x'03FFF') in memory pointer 1 is thesource address, and the address in memory pointer 0, for any memory space, is the destination address.When the first data byte transfer ends, the address in memory pointer 0 increments by one.In the second data byte transfer, the incremented address in memory pointer 0 becomes the sourceaddress, and the I/O space address (x'03F00' - x'03FFF') in memory pointer 1 becomes the destinationaddress. When the second data byte transfer ends, the address in memory pointer 0 increments again.Set the I/O address in lower 8 bits of memory pointer 1 (AT1MAP1L). The upper 10 bits of the I/O spaceaddress (x'03F') need not to be set in AT1MAP1H, AT1MAP1M.Figure 14-3-8 Transfer Mode 6
