First steps34 FP Web-Server V2.810 ENnetwork address, the other numbers define the participant's address. TheIP address of the FP Web-Server can be fixed or it can be allocateddynamically by a DHCP-Server.1. In a "self set-up" network (e.g. with only one hub) the IP addresses canbe assigned by yourselfIn this case, do not use DHCP. For further information refer to Setup ofan Individual Ethernet LAN (see p. 181).2. If the FP Web-Server is to be connected to an existing network, thefollowing data must be obtained from the network administrator: Is there a DHCP-Server in the network? If NOT: IP address: Which fixed IP address can be assigned to the FPWeb-Server? Netmask: How is the network address set up (length of the networkaddress and/or the participant's address)? Gateway: What is the gateway's IP address? (0.0.0.0 if there is nogateway to be used).3.6 Generate a new Configurator projectAfter having started the Configurator, a Configurator project can be openedfrom the local hard drive with [OPEN]. A Configurator project consists of: the configuration, the e-mail texts, and the HTML pages.Upon the initial start, the "default_project" is automatically offered with[OPEN]. With [OPEN] you can also load one of the examples (see"Description of the HTML examples" on p. 173). You can save it under anew name with [SAVE AS]. On the "Config" page you can adjust thefollowing, most important settings. You must configure at least thefollowing: The IP configuration (see "Determination of the IP configuration" on p.33) has to be entered according to the destination network.P r o c e d u r e
