5.4 MEWTOCOL-COM Master Communication (SEND)5-95.4.2 SEND Command (When MEWTOCOL-COM is Used) Command formatSettingitems Settings Setting rangei Specify the operation unit. US / SSS Specify the header of the source node data area. (Note 1) -n Specify the No. of sent data. 1 - 507 wordsor 1 bitD1 Specify the partner station no. (Note 2) (Note 3) 0 - 99D2 Specify the initial address of the receiver node data area in the partnernode. (Note 4) 0 - 99999D3 Specify the device area in the source node to save the execution resultcode (one word). (Note 5)(Note 1) Transmission methods vary by the type of device to be specified for the operands [S] and [D2].Device to be specified for [S2] and [D1] Transmissionmethod16 bit device: WX, WY, WR, WL, DT, LD Registertransmission1 bit device: X, Y, R, L, DT, n, LD, n Bit transmission(Note 2) The No. of sent data is on a word basis for register transmission, and on a bit basis for bit transmission.(Note 3) When "0" is specified for partner station no., global transmission is applied. In this case, no responsemessage is received from the partner side.(Note 4) Bit device DT, n and LD, n cannot be specified for the header of the receiver data in the partner node.(Note 5): Device that can be specified for [D3] are: WX, WY, WR, WL, DT, LD. Saved as one word in the specified area.0: Normal completion1: Communication port is being used for master communication2: Communication port is being used for slave communication3: No. of master communication commands that can be used simultaneously has been exceeded4: Sending timeout5: Response reception timeout6: Received data errorPhone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
