General-Purpose Communication7-87.3.4 Precautions on Sending Data Procedures when the end code is not added in the sending processWhen you do not wish to add the terminator (end code) in the sending process, use anegative value for specifying the No. of sent bytes.R0（ ）DFSSET DT100“ABCDE”R100R100R100NEG.SS DT100DT100GPSEND ． SS DT101 DT0DT100X8 Y8 GPSEND execution conditionsClear to send flag: ONSending flag: OFFBecause no end code is added,use a negative value forspecifying the No. of sent bytes.SEND processingS: Header of Sent Data (DT101)n: No. of Sent Characters (DT100)D: Execution Result Code (DT0)Clear to sendgeneral purposecommunication flagSending general-purposecommunication flagR100Data conversionS1: Sent DataS2: Save Sent DataDT100: No. of Sent CharactersDT101 onward: Sent DataR101（ ）DF（ ）DFY8 R101（ ）DF / Confirm sending completionReset GPSEND executionconditionsR100UNITSEL U1U0Settings for communication portS1: Slot 0 (U0)S2: COM1 (U1)S1 S2S1 S2S n DS1 DKEY POINTS When you do not wish to add the terminator (end code), use a negativevalue for specifying the No. of sent data in GPSEND command. Select "SS"for operation unit.Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
