6.3 How to Use Event Mail Transmission6-236.3.2.3 Mail Transmission Settings (SMTPcSET)• Configure the mail transmission settings.• CY (SR9) and SD29 are cleared to 0 when this instruction is executed. (Set when Ethernet isinitialized.)• Confirm if "X61: Ethernet initialization active" is OFF before executing the instruction.• It is necessary to specify 6.3.2.2 Destination Group Setting (SMTPcADD) or the event mailsetting by 6.3.1 Setting with Tool Software. Instruction format“Test”S3R0SMTPcSET “ID=0,TRIG=BITON,R0” “GRPNO=0,SUBJECTAUTO”S1 S2 S4"INFO=NON,ATT=NONE"X61 Operation unit (i)• There is no operation unit. List of operandsOperand DescriptionS1 Specify the starting address storing the setting number (string) and send trigger or a characterconstant.S2 Specify the starting address storing the subject of sent mail and destination group no. (string) or acharacter constant.S3 Specify the starting address storing the mail text to be sent or a character constant.S4 Specify the starting address storing the attached data specification of sent mail or a characterconstant. Available devices (●: Available)Operand16-bit device 32-bitdevice IntegerRealnum-berStringIndexmodifierWX WY WR WL WS SD DT LD UM WI WO TSCSTECE IX K U H SF DF " "S1 ● ● ● ● ● ● ●S2 ● ● ● ● ● ● ●S3 ● ● ● ● ● ● ●S4 ● ● ● ● ● ● ● Processing• Stores the mail transmission settings of S1 to S4 in the mail transmission setting area.• It is executable when all the send request relays of the mail send control relays are 0: Norequest. (When requested, an operation error occurs.)• It is executable when the Ethernet initialization done (X61) is OFF. If it is ON when executingthe instruction, an error is set to CY flag and it becomes no operation.
