Routing Setting3-23.1 Overview of Routing Setting Overview of Routing SettingWhen a partner device exists in a different network and that network is located in a placethrough a router other than the default gateway, the routing setting is used.DefaultroutergatewayRouterRouter1NodeIP addressP.P.P1.P1Internet addressQ.Q.x.x.Internet addressV.V.x.x.Register router IP addressesby the routing setting.Router6 IP addressP.P.P6.P6Local networkNetwork address PPxxAnother network AAnother network 1NodeAnother network 6To an arbitrary network Register the IP addresses of destinationnetworks by the routing setting. Items specified with tool softwareItem Default DescriptionRouting setting "Not use" For performing routing, select "IPv4 only" or "IPv6 only".Selecting either oneenables the route settings for 1 to 6.Route 1-6Destinationnetwork"0.0.0.0"(Not set)Specify the IP address (network address) of the destination network.Specify the IP address of the terminal (node) communicated. The settingrange for each segment is 0 to 255.Destiantionsubnet mask 1-6"0.0.0.0"(Not set)Specify the destination subnet mask. Set the subnet mask of the network towhich the terminal (node) communicated belongs. The setting range foreach segment is 0 to 255.Router IPaddress 1-6"0.0.0.0"(Not set)Specify the router IP address. Specify the IP address of the router used forcommunication. The setting range for each segment is 0 to 255.(Note): The above table shows the case that IPv4 is selected. When IPv6 is selected, different items are displayed.
