28VQT1D38Setupª About the remaining batterycapacity indicationThe remaining battery capacity is displayed inminutes when using the Panasonic battery thatyou can use for this unit. It may take time todisplay the remaining battery capacity.≥The display changes as the battery capacityreduces.# # # # .If there are less than 3 minutes, thenwill become red. If the battery discharges, then( ) will flash.≥The remaining battery capacity may not bedisplayed correctly where the temperature islow or high or if the battery was not used for along period of time.To correctly display the remaining batterycapacity, recharge the battery, discharge it andthen charge it again. (Even if this operation isperformed, it may not be possible to display theremaining battery capacity correctly if thebattery was used for a long period of timewhere the temperature is low or high or if thebattery was repeatedly charged.)≥The times of remaining battery capacityindication will vary depending on the status ofuse. These times are approximations.≥When turning the mode dial to switch modes,the time indication will turn off in order torecalculate the remaining battery capacity time.≥When using batteries made by othercompanies, the remaining battery capacity willnot be shown.Connecting to the AC outletThe unit is in the standby condition when the ACadaptor is connected. The primary circuit isalways “live” as long as the AC adaptor isconnected to an electrical outlet.≥Even if the battery is inserted in this unit, itwill not charge.1 Connect the AC cable to the ACadaptor.2 Connect the DC cable to the ACadaptor.3 Open the terminal cover on thisunit and connect the DC cable tothe DC input terminal[DC IN 9.3V].≥Do not use the AC cable with any otherequipment as it is designed only for thisunit. Do not use the AC cable from otherequipment with this unit.≥Put the battery on the AC adaptor to charge it.(l 25)≥While the DC cable is connected to the ACadaptor, the battery will not charge.30minDC IN 9.3V
