97VQT1D38With a computerConnection and recognitionAfter the software applications are installed, thisunit must be connected to the computer and becorrectly recognised by the computer.≥Connect after installing the softwareapplications.≥Remove the supplied CD-ROM if it is insertedin the computer. (If the [Setup Menu] screen isdisplayed, wait until it finishes and then removethe CD-ROM.)≥If the recognition procedure is notaccomplished properly, operation will not bepossible after connecting the unit to thecomputer.≥If the unit fails to operate normally, it may meanthat you have not conducted the installation orrecognition procedure properly.1 Insert the battery and connectthe AC adaptor.≥If you do not insert the battery and connectthe AC adaptor, operation will not bepossible after connecting this unit to thecomputer.2 Insert an SD card with recordedimages in this unit and then setthe mode dial to to turn onthe power.3 Connect this unit and acomputer.A USB cable (supplied)This unit is automatically recognised by thecomputer.≥Insert the plugs as far as they will go. The unitand computer will not operate properly if theplugs are not inserted fully.≥Do not use any other USB connection cablesexcept the supplied one. (Operation is notguaranteed with any other USB cables.)≥When the unit is connected to a computer,the operation mode cannot be changed andits power cannot be turned off.In this case, disconnect the USB cable (l 99).≥When a computer is accessing the SD card inthis unit, the card access lamp lights. (When acard is being accessed, appears on theLCD monitor.) Do not disconnect the USBcable or AC adaptor while the card is beingaccessed as it may damage the data.≥It may be necessary to reboot the computerafter connecting this unit to it for the first time.Connection and recognitionproceduresPCA
