Panasonic HDC-SD100 Operating Instructions Manual

Also see for HDC-SD100: Brochure Brochure & specs Operating instructions Operating instructions

Contents

Panasonic HDC-SD100 Operating Instructions Manual Manual pdf 34 page image

34VQT1T90This unit will resume recording pause modeabout 0.6 seconds after the LCD monitor isreopened.When in quick start standby mode about60% of the power used in recording pausemode is being consumed, so the recordingtime will be reduced.- Rotate the mode dial to select .1 Set the LCD/EVF select switch toLCD. ( 29)2 Select the menu. ( 22)3 Close the LCD monitor while themode dial is set to .The status indicator #flashes green and the unitgoes into quick start standby mode.The lens cover does not close.4 Open the LCD monitor.The status indicator #lights red and the unit isput into recording pause approx. 0.6 secondsafter it is turned on.Set [QUICK START] to [OFF] to cancel thequick start mode.Quick start standby mode is cancelled if$about 5 minutes elapsed$mode dial is set to$unit is turned offTime for quick start will be more than 0.6seconds slower in the following conditions.$When the digital cinema is used$When the unit is exposed to vibration orshockIn the quick start mode, it may take some timefor automatic white balance to adjust, if thescene being recorded has a light sourcedifferent from the scene last recorded. (Whenthe colour night view function is used, however,the white balance of the scene last recorded isretained.)In the quick start mode, the zoommagnification becomes 1# and the picture sizemay differ from what it was before quick startstandby mode.If [POWER SAVE] ( 24) is set to[5 MINUTES] and the unit automatically goesinto quick start standby mode, close the LCDmonitor and then open it again.The unit is put into recording pause approx.1.9 seconds when the mode dial is set tofrom OFF.Start time will not shorten if there is no SD cardinserted.- Rotate the mode dial to select .Select the menu. ( 22)This function’s default setting is [ON].Set [QUICK POWER ON] to [OFF] to cancelthe quick power on.In the quick power on mode, the zoommagnification becomes 1# and the picture sizemay differ from what it was before turningpower off.Quick start[SETUP] [QUICK START] [ON]Quick power on[SETUP] [QUICK POWER ON] [ON]