Panasonic HDC-SD9D Operating Instructions Manual

Also see for HDC SD9 - Camcorder - 560 KP: Brochure & specs Operating instructions Brochure & specs

Contents

Panasonic HDC-SD9D Operating Instructions Manual Manual pdf 35 page image

35VQT1N58This unit will resume recording/pause modeabout 0.6 seconds after the LCD monitor isreopened.≥ When in quick start standby mode about60% of the power used in recording pausemode is being consumed, so the recordingtime will be reduced.1 Select the menu. (l 21)2 Close the LCD monitor while themode switch is set to .The status indicator A flashes green and the unitgoes into quick start standby mode.≥ The lens cover does not close.3 Open the LCD monitor.The status indicator A lights red and the unit isput into recording pause approx. 0.6 secondsafter it is turned on.≥ Set [QUICK START] to [OFF] to cancel thequick start mode.≥ Quick start standby mode is cancelled ifjabout 5 minutes elapsedjSet the mode switch tojTurn the unit off≥ In the 25p digital cinema setting, the requiredtime for the quick start operation is slightlylonger than 0.6 seconds.≥ In the quick start mode, it may take some timefor automatic white balance to adjust, if thescene being recorded has a light sourcedifferent from the scene last recorded. (Whenthe colour night view function is used, however,the white balance of the scene last recorded isretained.)≥ In the quick start mode, the zoommagnification becomes 1k and the picture sizemay differ from what it was before quick startstandby mode.≥ If [POWER SAVE] (l 22) is set to[5 MINUTES] and the unit automatically goesinto quick start standby mode, close the LCDmonitor and then open it again.≥ If the unit is exposed to vibration or shock, thetime for the quick start mode may be slightlylonger than 0.6 seconds.This allows recording of the pictures and soundto start approximately 3 seconds before therecording start/stop button is pressed.1 Press the PRE-REC button.[ ] appears on the screen and the unitrepeats the update by recording motion picturesfor about 3 seconds onto the built-in memory andthen deleting them.≥ Aim this unit at the subject and position itsecurely.≥ Press the PRE-REC button again to cancel thesetting.2 Press the recording start/stopbutton to start recording.≥ Images and audio are recorded for about3 seconds before pressing the recording start/stop button.≥ There is no beep sound.≥ After recording starts, the PRE-REC setting iscancelled.≥ To use the PRE-REC function again, press thePRE-REC button again.Quick start[SETUP] # [QUICK START] # [ON]PRE-RECThis prevents you missing a shot.PRE-REC