99VQT1N58Setup2 Connection and recognitionAfter the software applications are installed, this unit must be connected to the PC and be correctlyrecognised by the PC.≥ Remove the supplied CD-ROM from your PC.A USB cable (supplied)1 Connect this unit to the ACadaptor.≥ If a battery is used, operation is not possiblewhen this unit is connected to a PC.2 Turn on the unit.≥ This function is available in all modes.3 Connect this unit to a PC.≥ Insert the USB connectors as far as they will go.≥ Do not use any other USB connection cablesexcept the supplied one. (Operation is notguaranteed with any other USB cables.)4 Select [PC CONNECT] and pressthe cursor button.≥ This unit is automatically detected by the PC.≥ When the unit is connected to a PC, theoperation mode cannot be changed and itspower cannot be turned off.Disconnect the USB cable, before turningthis unit off.≥ Do not disconnect the USB cable or the ACadaptor while the card access lamp is on orcard access icon ( ) appears on the LCDmonitor. Doing so may damage the data.∫ If the driver has not beenrecognised properlyUse the following methods to enable it to berecognised.Method 1:Turn off the unit and your PC once and tryverifying again.Method 2:Remove the SD card and try verifying again.Method 3:Try connecting the unit to another USB port onyour PC.∫ To disconnect USB cable safely1 Double click the ( ) icon in tasktray displayed on the PC.≥ Depending on your PC’s settings, this iconmay not be displayed.2 Select [USB Mass Storage Device] andclick [Stop].3 Verify [MATSHITA HDC-SD9/SD USBDevice] is selected and click [OK].
