Others137VQT1J42It is possible that the system cannot complete writing of a file normally when, for example, power isturned off for some reason during recording or editing.If faulty management information is found when a disc or an SD card is accessed, the followingmessage may appear. (Repairing may take time depending on the error.)¬ HD modeWhen connecting to AC adaptor or the remaining capacity of the battery is enough:[FINISHED.]When the remaining capacity of the battery is low:[CANNOT REPAIR CONTROL INFORMATION DUE TO LOW BATTERY POWER.]When connecting to AC adaptor or the remaining capacity of the battery is enough:[THUMBNAIL DATA HAS BEEN REPAIRED SUCCESSFULLY.]When the remaining capacity of the battery is low:[CANNOT REPAIR CONTROL INFORMATION DUE TO LOW BATTERY POWER.]¬ STD mode≥ Use a sufficiently charged battery or the AC adaptor.≥ Depending on the condition of the data, it may not be possible to completely repair the data.≥ If the recovery fails, you will no longer be able to playback the data recorded before the power wentoff.≥ When data recorded on another device is recovered, it may not be possible to play back the data onthis unit or the other device.≥ If the thumbnail information is recovered, displaying the thumbnails may become slower.CANNOT SET. The [GUIDE LINES], [ZEBRA], [MF ASSIST], [MIC LEVEL] and[RED EYE] menu settings cannot be set when the color bar is set.DISCONNECT USBCABLE.The unit cannot correctly establish the connection to the computeror printer. Disconnect and then reconnect the USB cable.(HD mode) DISCONNECTUSB CABLE.The unit’s power cannot be turned off when the unit is connected tothe computer.(STD mode) CANNOTOPERATE WHILECONNECTED TOCOMPUTER.About recoveryCONTROL DATA ERROR HAS BEENDETECTED.THUMBNAIL DATA ERROR IS DETECTED.DISC ERROR HAS OCCURRED. NOWREPAIRING DATA ON THE DISC.
