Panasonic KX-FP342BX Service Manual

Bit No. DIS/DTC DCS41 R8×15.4 lines/mm R8×15.4 lines/mm42 300×300 pels/25.4 mm 300×300 pels/25.4 mm43 R16×15.4 lines/mm and/or 400×400 pels/25.4 mm R16×15.4 lines/mm and/or 400×400 pels/25.4 mm44 Inch based resolution preferred Resolution type selection"0" : neuritic based resolution"1" : inch based resolution45 Metric based resolution preferred Don’t care46 Minimum scan line time capability for higher resolutions"0" : T 15.4 = T 7.7 "1" : T 15.4 = 1/2T 7.7Don’t care47 Selective Polling capability Set to "0".48 Extend field Extend fieldNote 1 - Standard facsimile units conforming to T.2 must have the following capability : Index of cooperation (IOC)=264.Note 2 - Standard facsimile units conforming to T.3 must have the following capability : Index of cooperation (IOC)=264.Note 3 - Standard facsimile units conforming to T.4 must have the following capability : Paper length=297 mm.Signal Identification Signal Format FunctionTraining 1 ——————— A fixed pattern is transmitted to the receiving side at a speed (2400 to9600 bps) designated by DCS, and the receiving side optimizes theautomatic equalizer, etc., according to this signal.TCF(Training Check)——————— Sends 0 continuously for 1.5 seconds at the same speed as thetraining signal.CFR(Confirmation to Receive)X0100001 Notifies the sending side that TCF has been properly received. If TCFis not properly received, FTT (Failure To Train) X0100010 is relayed tothe sender. The sender then reduces the transmission speed by onestage and initiates training once again.Training 2 ——————— Used for reconfirming the receiving side like training 1.Image Signal Refer to the next page. ———————RTC(Return to Control)——————— Sends 12 bits (0...01 × 6 times) to the receiver at the same speed asthe image signal and notifies completion of transmission of the firstsheet.EOP(End of Procedure)X1110100 End of one communicationMCF(Message Confirmation)X0110001 End of 1 page receptionDCN(Disconnect)X1011111 Phase E starts.MPS(Multi-Page Signal)X1110010 Completion of transmission of 1 page. If there are still more documentsto be sent, they are output instead of EOP. After MCF reception, thesender transmits an image signal of the second sheet.PRI-EOP(Procedural Interrupt-EOP)X1111100 If there is an operator call from the sender, it is output after RTC.PIP(Procedural Interrupt Positive)X0110101 This is output when an operator call is received.142KX-FP342BX