Panasonic KX-FP342BX Service Manual

6.6.5.1.8. HOW TO OUTPUT THE JOURNAL REPORT1. Press [MENU] button.2. Press [#], then [8] and [4].3. Press [SET] button.4. The report is printed out.Error code table:(1) CODE (2) RESULT (3) MODE SYMPTOM Counter-measure*PRESSED THE STOP KEY SND & RCV Communication was interrupted by the STOP button.DOCUMENT JAMMED SND The document paper is jammed.NO DOCUMENT SND No document paper.28 COMMUNICATION ERROR SND & RCV -40 OTHER FAX NOT RESPONDING SND Transmission is finished when the T1 TIMER expires. 141 COMMUNICATION ERROR SND DCN is received after DCS transmission. 242 COMMUNICATION ERROR SND FTT is received after transmission of a 2400BSP training signal. 343 COMMUNICATION ERROR SND No response after post message is transmitted three times. 444 COMMUNICATION ERROR SND RTN and PIN are received. 546 COMMUNICATION ERROR RCV No response after FTT is transmitted. 648 COMMUNICATION ERROR RCV No post message. 749 COMMUNICATION ERROR RCV RTN is transmitted. 850 COMMUNICATION ERROR RCV PIN is transmitted (to PRI-Q). 851 COMMUNICATION ERROR RCV PIN is transmitted. 852 OTHER FAX NOT RESPONDING RCV Reception is finished when the T1 TIMER expires. 954 ERROR-NOT YOUR UNIT RCV DCN is received after DIS transmission. 1158 COMMUNICATION ERROR RCV DCN is received after FTT transmission. 1359 ERROR-NOT YOUR UNIT SND DCN responds to the post message. 1465 COMMUNICATION ERROR SND DCN is received before DIS reception. 265 COMMUNICATION ERROR RCV Reception is not EOP, EOM PIP, PIN, RTP or RTN. 268 COMMUNICATION ERROR RCV No response at the other party after MCF or CFR is transmitted. 1370 ERROR-NOT YOUR UNIT RCV DCN is received after CFR transmission. 1372 COMMUNICATION ERROR RCV Carrier is cut when the image signal is received. 1674 JUNK FAX PROH. REJECT RCV The junk fax prohibitor of your unit rejected fax reception.75 MEMORY FULL RCV The document was not received due to memory full.79 CANCELED SND The multi-station transmission was rejected by the user.FF COMMUNICATION ERROR SND & RCV Modem error. For the DCN, DCN, etc. abbreviations, refer toMODEM SECTION (P.138).12SND=TRANSMISSION RCV=RECEPTIONMost fax communication problems can be resolved by the following steps.1. Change the transmit level. (Service code: 596, refer to SERVICE FUNCTION TABLE (P.48).)2. Change the TX speed/RX speed. (Service code: 717/718, refer to SERVICE FUNCTION TABLE (P.48).)Note*:If the problem remains, see the following "Countermeasure" flow chart.84KX-FP342BX