· There is something wrong with the unit.· The document was not fed into the unit properly.Reinsert the document. If misfeeding occurs frequently,clean the document feeder rollers and try again. (Referto DOCUMENT FEEDER (P.27).)· Attempted to transmit a document longer than 600 mm.Press the [STOP] to remove the document. Divide thedocument into two or more sheets and try again.· [Alternately, turn off service code #559 to enablesending of documents longer than 600 mm] (Refer toSERVICE FUNCTION TABLE (P.48).)· The memory (telephone numbers, parameters, etc.) hasbeen erased. Re-program.[The backup lithium battery on the top of the digitalboard may be low or dead, so check it.]· The recording paper is not installed or the unit has runout of paper. Install paper and press [SET] to clear themessage.· The recording paper is not fed into the unit properly.Reinstall paper and press [SET] to clear the message.(Refer to INSTALLING THE RECORDING PAPER(P.16).)· The recording paper has jammed near the recordingpaper entrance. Clear the jammed paper and press[SET] to clear the message. Do not install folded orheavily curled paper. (Refer to RECORDING PAPERJAMS (P.25).)· The back cover is open. Close it.· There is no space to store new entries in navigatordirectory. Erase unnecessary entries.· The unit has a document in memory. See the otherdisplayed message instructions to print out thedocument.· The memory is full of received documents due to lack ofrecording paper or a recording paper jam. Install paperor clear the jammed paper. (Refer to RECORDINGPAPER JAMS (P.25).)· When performing memory transmission, the documentbeing stored exceeds the memory capacity of the unit.Transmit the entire document manually.· The film is empty. Replace the film with a new one.(Refer to INSTALLING THE INK FILM (P.15).)· The ink film is slack. Tighten it and install again. (Referto RECORDING PAPER JAMS (P.25).)· The remaining film is low. Prepare a new film. (Refer toINSTALLING THE INK FILM (P.15).)· When making a copy, the document being storedexceeds the memory capacity of the unit. Press [STOP]to clear the message. Divide the document intosections.6 TROUBLESHOOTING GUIDE6.1. USER RECOVERABLE ERRORSIf the unit detects a problem, one or more of the following messages will appear on the display.The explanations given in the [ ] are for servicemen only.45KX-FP342BX