Panasonic KX-FP81BX Service Manual

Contents

(25) NUM(BER OF RECORDING MESSAGEThe number of messages recorded in TAM.(26) NUMBER OF PC SCANThe number of times multifunction was used for the Scanner. (The number of pages scanned. If the unit does not have a PCinterface, NONE will be printed.)(27) NUMBER OF PC-PRINTThe number of times multifunction was used for the Printer. (The number of pages printed. If the unit does not have a PC interface,NONE will be printed.)(28) NUMBER OF RECEIVING TO PCThe number of times received in the PC through the FAX serial interface (RS232C). (The number of pages received. If the unit doesnot have a PC interface, NONE will be printed.)(29) NUMBER OF SENDING FROM PCThe number of times transmitted from the PC through the FAX serial interface (RS232C). (The number of pages transmitted. If theunit does not have a PC interface, NONE will be printed.)(30) NUMBER OF PRINTING WARNING LISTThe number of warning lists printed until now.(31) NUMBER OF PRINTING HELPThe number of help lists printed until now.(32) NUMBER OF DIVIDED PRINTING IN FAX RECEPTIONThe number of faxes received that were divided into more than one sheet since the unit was purchased.(33) DETECTION OF RS232CWhen the fax and PC serial cable (RS232C) are connected and the signal is received correctly, COMPLETE will be printed. Formodels without a PC interface or when there is a PC interface but the signal cannot be received between the fax and PC,INCOMPLETE will be printed. (The number of pages transmitted. If the unit does not have a PC interface, NONE will be printed.)(34)Not Used(35)Not Used(36) FAX MODEMeans the unit received a fax message in the FAX mode.(37) MAN RCVMeans the unit received a fax message by manual operation.(38) FRN RCVMeans the unit received a fax message by friendly signal detection.(39) VOXMeans the unit detected silence or no voice.(40) RMT DTMFMeans the unit detected DTMF (Remote Fax activation code) entered remotely.(41) PAL DTMFMeans the unit detected DTMF (Remote Fax activation code) entered by a parallel connected telephone.(42) TURN-ONMeans the unit started to receive after 15 rings. (Remote Turn On: Service Code #573)(43) TIME OUTMeans the unit started to receive after Ring Time Out in the EXT-TAM or TEL/FAX mode.(44) IDENTMeans the unit detected Ring Detection.(45) CNG OGMMeans the unit detected the CNG while it was sending the Dummy Ring Back Tone in the TEL/FAX mode, or while answering acall in the EXT-TAM mode. Or means the unit detected the CNG while it was sending the OGM in the ANS/FAX mode.(46) CNG ICMMeans the unit detected the CNG while it was recording the ICM in the ANS/FAX mode.(47) Not Used(48) ICU VERSIONImage Control Software Version.92KX-FP81BX / KX-FP81CX / KX-FP82CX