3.1 Making CallsThis section explains the basic methods for making a call.• You can confirm that the number was dialed correctly before calling (Predialing) by entering the number,then going off-hook.• To clear an entire number while predialing, pressClear for more than 1 second.• To cancel dialing, press / CANCEL .• To insert a 3 second pause between phone numbers, pressPause .*1It is useful when you want to operate voice mail service without listening to pre-recorded announcement,for example. Repeat as needed to create longer pauses.• The "+" symbol (international dialing code) can be entered by pressing and holding the key.*1 This soft key is displayed only when configured on the telephone. Contact your administrator for further information.3.1.1 Basic CallingCalling by Dialing1. In standby mode, go off-hook.2. Dial the outside party’s number.3. PressCall .4. Go on-hook to end the call.Note• For KX-HDV130: You can use a specific line by pressing / LINE 1/P1 or / LINE 2/P2 assignedto a line or by using the Line Status screen (see "3.7 Checking the Line Status").• For KX-HDV230: You can use a specific line by pressing a function key assigned to a line (see"4.5.2 The Types of Function Keys") or by using the Line Status screen (see "3.7 Checking the LineStatus").• To dial a new number without going on-hook, follow the procedure below.1. PressMenu .2. Press [▲] or [▼] to select "Flash/Recall".3. PressOK .PredialingIn standby mode, you can start dialing while still on-hook. After dialing the number, go off-hook to begin thecall.3.1.2 Easy DialingUsing the redial listThe last phone number dialed is stored in the redial list.1. In standby mode, press / / REDIAL .2. Go off-hook.*1*1 When you do not go off-hook at this step, it will be a call using the speakerphone.3.1 Making Calls48 Operating Instructions Document Version: 2017-08