5.4 Programming the PBX5.4.1 Easy Setup WizardIn the Easy Setup Wizard, you will set up the mandatory settings required for the PBX.When you log in to Web Maintenance Console for a PBX that is in its initialised, factory default state, the EasySetup Wizard for that PBX will launch automatically. You must log in using the Installer level account nameand password.– The Installer level account name is "INSTALLER".– The default Installer level account password is "1234".1. After Easy Setup Wizard launches, the Easy Setup Wizard screen appears:a. In WebMC Language Setting, select a language from the drop-down list.b. In Location Setting, select a location from drop-down list.c. In Password Setting, enter a password for the Installer level account. In Re-enter, enter the samepassword.d. Click Start Setup Wizard.NoteIf the location is changed from its default value, a notice about restarting the PBX is displayed. ClickOK to restart the PBX. After the PBX restarts, start Web Maintenance Console again (refer to"Connecting to Web Maintenance Console" in "5.3 Starting Web Maintenance Console"). When youstart the Easy Setup Wizard again, you will start from step 1, below.2. In the Date & Time Settings:a. Select a time zone from the drop-down list.b. Click the Local Time box, and then select the date and time from the menu.c. In Automatic Time Adjustment, enter information as necessary.d. In Daylight Saving, select the appropriate option.e. Click Next.3. In the Numbering settings:a. In Feature Number, select the appropriate option.b. In CO Access/Operator Number, select the appropriate options.c. Select one of the following options for Select the default value of numbering plan:– 3 digits Extension Number– 4 digits Extension Numberd. Click Next.NoteDepending on the value selected above, the numbering plan of the PBX will vary as follows. Select thisvalue with care.Installation Manual 1655.4.1 Easy Setup Wizard