Panasonic KX-P8415 Setup And Reference Manual

Also see for KX-P8415: Maintenance Guide Settings guide Operating instructions Specifications

CautionThis printer utilizes a laser. Use of controls oradjustments or performance of procedures otherthan those specified herein may result inhazardous radiation exposure.WarningMake sure that the printer is installed in a wellventilated room so as not to increase density ofozone in the air. Since ozone is heavier than air, itis recommended that air at floor level be ventilated.The printer weighs approximately 49.2 kg {108.4lbs.}. It must be handled by two people. Turn thepower off and remove the power cord whenhandling the unit.4Ozone ReleaseLaser diode propertiesLaser output : 5 mW maxWavelength : 780 nmEmission duration : ContinuousWarningTo prevent fire or shock hazard, do not expose thisproduct to rain or any type of moisture.CautionDo not open covers and do not attempt to repair theunit yourself. Refer servicing to qualified personnel.WarningBThe power source voltage of this unit is listed onthe nameplate. Only plug the unit into an outletwith the proper voltage.BWhen you operate this equipment, the outletshould be near the equipment and accessible.BTo ensure safe operation the AC cord suppliedmust be inserted into standard three-prong ACoutlet which is effectively grounded (earthed)through the normal wiring.BThe fact that the equipment operatessatisfactorily does not imply that the power pointis grounded (earthed) and that the installation iscompletely safe. For your safety, if in any doubtabout the effective grounding (earthing) of thepower point, consult a qualified electrician.BIf the plug cannot be inserted into the AC outlet,contact a licensed electrician to replace the outletwith a properly grounded (earthed) one.BDo not defeat the purpose of the grounding(earthing) plug (ex. do not use a conversionplug).For Your SafetyGeneralMoving the UnitLaser SafetyPower Source