General FeaturesFeatures Guide 11Account Code EntryDescriptionAn Account Code is used to identify incoming and outgoing outside calls for accounting andbilling purposes. The account code is appended to the Station Message Detail Recording(SMDR) call record. For incoming outside calls, account codes are optional. For outgoingoutside calls, there are three modes available to enter an account code: Verified-All Callsmode; Verified Toll Restriction Override mode; and Option mode. One mode is selected foreach extension on a Class of Service basis.In Verified-All Calls mode, the user must always enter a pre-assigned account code whenmaking any of the following calls.• Call Forwarding — to Outside Line• Line Access• One-Touch Dialing• Personal Speed Dialing• Pickup Dialing• System Speed DialingIf you use Last Number Redial or Saved Number Redial, you do not have to re-enter theAccount Code.In Verified-Toll Restriction Override mode, the user can enter a pre-assigned account codeonly when the user needs to override toll restriction.In Option mode, the user can enter any account code if needed.Conditions• An account code can be stored into Memory Dialing (System / Personal Speed Dialing;One-Touch Dialing; Pickup Dialing; Call Forwarding — to Outside Line).• The Account button may be used in place of the feature number. A flexible button on theproprietary telephone set can be programmed as the Account button.• Account code entry after Calling Party Control (CPC) Signal Detection must be done within15 seconds. Otherwise, SMDR call record is activated and entry becomes impossibleafterwards.• If disconnection signal is selected in program [990], Area 01 - Bit 3, the Verified-All Callsextension is allowed to make an outside call using the same line with Flash function.• In any mode, emergency dial numbers stored in program [334] "Emergency Dial NumberSet" can be dialed out without an account code entry.• If the account code is entered several times, the last entered code is printed out in the StationMessage Detail Recording (SMDR).Program [990], Area 06 - Bit 5, can disable overwriting the data to print out the first enteredcode.
