Panasonic KX-TCD430AL Operating Instructions Manual

26Multi-unit OperationL If you changed PIN, enter it (page 22).8 Press {>}.L When the handset has been registeredsuccessfully, a confirmation tone willsound, and w will stop flashing.Note:L If all registered handsets start ringing instep 5, press {x} to stop, then start againfrom step 1.Selecting a base unitWhen “AUTO” is selected, the handset willautomatically use any available base unit itis registered to. When a specific base unit isselected, the handset will make and receivecalls using that base unit only. If the handsetis out of range of that base unit, no calls canbe made.1 Press {j}.2 Press {v} repeatedly to display“SETTING HS”, then press {>}.3 Press {v} repeatedly to display “SELECTBS”, then press {>}.4 Press {v} repeatedly to display “AUTO”or a specific base unit number, thenpress {>}.L The handset starts searching for thebase unit.Note:L When a handset is registered to anotherbase unit, this setting will automaticallychange to that base unit’s number even if“AUTO” was selected.Cancelling a handsetA maximum of 6 handsets can be registeredto a base unit. A handset can cancel its ownregistration (or the registration of anotherhandset) that is stored in the base unit. Thiswill allow the base unit to “forget” thehandset.1 Press {j}.2 Press {v} repeatedly to display“SETTING BS”, then press {>}.3 Press {7}.4 Enter “0000” (default base unit PIN).L If you changed PIN, enter it (page 22).5 Press the desired handset number.L The selected handset number willflash.6 Press {>}.7 Wait until “SETTING BS” is displayed,then press {ih}.Cancelling a base unitA handset can be registered to a maximumof 4 base units. A handset can cancel a baseunit that it is registered to. This will allow thehandset to “forget” that base unit.1 Press {j}.2 Press {v} repeatedly to display“SETTING HS”, then press {>}.3 Press {v} repeatedly to display“REGISTRATION”, then press {>}.4 Press {v} repeatedly to display “CANCELBS”, then press {>}.5 Enter “0000” (default handset PIN).L If you changed PIN, enter it (page 21).6 Press {v} repeatedly to select thedesired base unit number, then press{>}.L The selected base unit number willflash.7 Press {>}.8 Press {v} repeatedly to select “YES”,then press {>}.L To stop cancelling, select “NO”.9 Press {ih}.Note:L To register the handset to another baseunit or to the same base unit again, seemanual registration (page 25).TCD430AL(E).book Page 26 Tuesday, March 30, 2004 5:27 PM