2.5 Utility92 PC Programming Manual2.5.16 Utility—Timed UpdateUpdates programs in the LPR cards (optional service cards with local processors) by comparing themwith files found on the SD memory card on a preset schedule, and downloading newer files to thecards.This option is only available at Installer level.It is recommended to set the timed update to take place during the least active time period, forexample late at night.Cards are automatically set to OUS status during an update, and returned to INS status when theupdate is complete.This utility does not apply to CS programs. These must be updated manually using the SD Card FileView and Load utility (see 2.5.4 Utility—SD Card File View and Load).When this utility has been set, all commands that would affect the status of cards are prevented fromoperating.The list of these commands is as follows:• Card status change (INS/OUS)• Diagnosis commands• Card installation• Card deletion• Remote reset• LPR program download requests• ISDN automatic setup requests (BRI card)• Signalling Bit Monitor requests (T1/E1)• Line trace start requests (T1/E1)• ISDN/QSIG Protocol Data Trace start requests• Time setting• CS program download requests• File deletionWhen a function other than those listed above, that cannot be performed while Timed Update hasbeen set, is selected, an error message will be displayed.To turn this utility on:1. From the Utility menu, select Timed Update.2. Select the Set option.The time setting box will become available.3. Enter the desired time using the number keys.Click in the hour or minute field and use the up and down arrows to adjust the displayed time inincrements of one unit.4. Click Apply.A message box will be displayed.5. Click OK.To turn this utility off:1. From the Utility menu, select Timed Update.
