Useful Information31For assistance, please visit http://www.panasonic.com/helpError messagesTroubleshootingIf you still have difficulties after following the instructions in this section, disconnect the base unit’sAC adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the handset,and then insert the batteries into the handset again.General useDisplay message Cause/solutionBusy L The called unit is in use.L Other units are in use and the system is busy. Tryagain later.L The handset you are using is too far from the baseunit. Move closer and try again.L There is no handset registered to the base unitmatching the handset number you entered.Error!! L Recording was too short. Try again.No link to base. Reconnectmain base AC adaptor.L The handset has lost communication with the baseunit. Move closer to the base unit and try again.L Unplug the base unit’s AC adaptor to reset the unit.Reconnect the adaptor and try again.L The handset’s registration may have been canceled.Re-register the handset (page 20).Problem Cause/solutionThe handset does not turn oneven after installing chargedbatteries.L Place the handset on the base unit or charger to turn onthe handset.The unit does not work. L Make sure the batteries are installed correctly (page 8).L Fully charge the batteries (page 8).L Check the connections (page 8).L Unplug the base unit’s AC adaptor to reset the unit.Reconnect the adaptor and try again.L The handset has not been registered to the base unit.Register the handset (page 20).TG122x.book Page 31 Wednesday, September 29, 2010 2:13 PM