Multi-unit Operation353 “Register H.set” i #4 Select a base unit number. i #L This number is used by the handsetas a reference only.5 Press and hold {x} on the base unit forabout 3 seconds, until the registrationtone sounds.L If all registered handsets start ringing,press {x} to stop, then repeat thisstep.L After pressing {x}, the rest of thisprocedure must be completed within 1minute.6 Wait until “Enter Base PIN” isdisplayed, then enter the base unit PIN(default: “0000”), then press #.L When the handset has beenregistered successfully, w will stopflashing. If keytones are turned on(page 21), a confirmation tone will beheard.Selecting a base unitWhen “Auto” is selected, the handset willautomatically use any available base unit itis registered to. When a specific base unit isselected, the handset will make and receivecalls using that base unit only. If the handsetis out of range of that base unit, no calls canbe made.1 " (middle soft key) i N i #2 “Select Base” i #3 Select the desired base unit number, or“Auto”. i #L The handset starts searching for thebase unit.Cancelling a handsetA maximum of 6 handsets can be registeredto a base unit. A handset can cancel its ownregistration (or the registration of anotherhandset) that is stored in the base unit. Thiswill allow the base unit to “forget” thehandset.1 " (middle soft key) i L i #2 Enter “335”.3 “Cancel Handset” i #L The numbers of all handsetsregistered to the base unit aredisplayed.4 Select the handset(s) you want tocancel, by pressing the desired handsetnumber. i #5 “Yes” i # i {ih}Cancelling a base unitA handset can be registered to a maximumof 4 base units. A handset can cancel a baseunit that it is registered to. This allows thehandset to “forget” the base unit.1 " (middle soft key) i N i #2 “Registration” i #3 Enter “335”.4 “Cancel Base” i #5 Select the base unit(s) you want tocancel, by pressing the desired base unitnumber. i #6 “Yes” i # i {ih}Note:L To register the handset to another baseunit or to the same base unit again, seemanual registration (page 34).Increasing the range of the baseunitYou can increase the signal range of thebase unit by using a DECT repeater. Pleaseuse only the Panasonic DECT repeaternoted on page 4. Consult your Panasonicdealer for details.TG1861AL(e).book Page 35 Friday, March 31, 2006 3:28 PM