Voice Mail Service32Setting Voice Mail (VM) Tone DetectionYour telephone company sends special signals (Voice mail tones) to activate theVM indicator.Press [ ] or [ ] to listen to the dial tone. If you hear a pulsating tone followed bya continuous dial tone, this is an indication that a new message was recorded.Your phone does not come set to detect these tones (set to OFF). After you hangup or the phone stops ringing, your unit will seize the phone line and check if amessage has been recorded. If a new message was recorded at your telephonecompany, “Voice Mail” will be displayed on the handset and the VM indicator onthe base unit will flash.Set this programming to OFF when:— you do not subscribe to a voice mail service,— your telephone company does not send a pulsating tone, followed by acontinuous dial tone, or— your unit is connected to a business or office telephone system (PBX).If you are not sure which setting is required, consult your local telephone companyor contact the Panasonic Customer Call Centre.1 Press [MENU].2 Scroll to “Initial setting” by pressing [ ]or [ ], then press Select.3 Scroll to “Voice Mail” by pressing [ ] or[ ], then press Select.4 Scroll to “VM tone detect” by pressing [ ]or [ ], then press Select.5 Select “On” or “Off” by pressing [ ] or [ ].6 Press Save, then press [OFF].>> Initial settingExit Select>>>> Voice MailBack Select>>>> VM tone detectBack Select>>>> VM tone detect:OffBack Save>>