23Basic OperationFor assistance, please call: 1-800-211-PANA(7262)To put a call on holdPress (HOLD/INTERCOM/CLEAR) twice.•The IN USE/HOLD indicator light flashes, “Hold” isdisplayed and the call is put on hold.•To transfer the call to another handset, see page 40.•If a call is kept holding for 6 minutes, an alarm tone will start to sound. After 4additional minutes on hold the call will be disconnected.•When you put on hold the call, “Line on hold” is shown on the display of otherhandsets.To release the holdPress or .•Another handset user can also release the hold by pressing or .•If another phone is connected on the same line (p. 52), you can also release thehold by lifting its handset.Hold [1]To adjust the receiver volume (HIGH, MEDIUM or LOW) orspeaker volume (6 levels) while talkingTo increase, press Ñ.To decrease, press Ö.•Each time you press Ö or Ñ, the volume level willchange.•The number of steps indicates the volume level.•The display will return to the length of the call.Backlit LCD displayThe lighted handset display will stay on for a few seconds after pressing ahandset button, lifting the handset off the base unit or the charger,hanging up a call, leaving the programming mode or ending the intercom.Lighted handset keypadThe handset dialing buttons will light when you press a button, lift thehandset off the base unit or the charger, or when a call is received.The lights will go out a few seconds after pressing a button, lifting thehandset, answering a call, hanging up a call, leaving the programmingmode or ending the intercom.Ex. Receiver volume: HighSpeaker volume: Level 6LoudLow HighGF