1 Press (MUTE/FUNCTION) and scroll to“Initial set” by pressing Ö or Ñ, andpress á.2 Scroll to “Voice mail” by pressing Ö orÑ, and press á.3 Press á at “VM tone detect”.•The current setting is displayed.4 Select “On” or “Off” by pressing Ö or Ñ.5 Press á (Save key).•A beep sounds.•To exit the programming mode, press (OFF).•You can exit the programming mode any time by pressing (OFF).44VM tone detect:OnGF H=SaveVM tone detect:OnVoice Mail ServiceSetting the Voice Mail (VM) Tone DetectionYour telephone company sends special signals (Voice mail tones) toactivate the voice mail display. Press or to listen to the dialtone. If you hear a series of dial tones followed by a continuous dial tone,this is indication that a new message was recorded. Your phone comesset to detect these tones (set to “On”). Minutes after you hang up or afterthe phone stops ringing, your unit will seize the phone line and check if amessage has been recorded. If a new message was recorded at yourtelephone company, “Voice mail” will be displayed on the handset.Set this programming to “Off” when:—you do not subscribe to a voice mail service,—your telephone company does not send a series of tones, followed by acontinuous tone, or—your phone is connected to a business or office telephone system (PBX).Please refer to below to set this programming to OFF.If you are not sure which setting is required, consult your local telephonecompany or contact Panasonic Customer Call Center.Make sure the unit is not being used and the handset is lifted off thebase unit.--------------HVM tone detectSave VM acces#Ringer settingHInitial set--------------Set tel lineHVoice mailHS register