Getting Started121 {j/OK}2 {V}/{^}: “Base Unit Setup” i{j/OK}3 {V}/{^}: “Dial Mode” i{j/OK}4 {V}/{^}: Select the desired setting.i {j/OK} i {ic}Date and time1 {j/OK}2 {V}/{^}: “Handset Setup” i{j/OK}3 {V}/{^}: “Set Date & Time” i{j/OK}4 Enter the current date, month, andyear.Example: 15 July, 2010{1}{5} {0}{7} {1}{0}5 Enter the current hour and minute.Example: 9:30{0}{9} {3}{0}L You can select 24-hour or 12-hourclock format (“AM” or “PM”) bypressing {*}.6 {j/OK} i {ic}Note:L To correct a digit, press {<} or {>} tomove the cursor to the digit, thenmake the correction.L The date and time may be incorrectafter a power failure. In this case, setthe date and time again.One touch eco modeThe {ECO/R} button on the handsetenables you to activate the eco functionwith one touch.By activating eco mode, your unit canreduce the base unit transmission powerby up to 90% in standby mode.You can turn on/off one touch eco modeby just pressing {ECO/R}. The defaultsetting is “Normal”.– When the one touch eco mode is on:“Low” is temporarily displayed and“ECO” is shown on the handsetdisplay.– When the one touch eco mode is off:“Normal” is temporarily displayedand “ECO” goes off from the handsetdisplay.Note:L When there is another cordless phonenearby and it is in use, the base unittransmission power may not bereduced.L Activating one touch eco modereduces the range of the base unit instandby mode.L If you set the repeater mode to “On”(page 20), one touch eco mode iscancelled.TG2511_2521CX(e-e).book Page 12 Thursday, March 11, 2010 10:34 AM