Making/Answering Calls13Making calls1 Lift the handset and dial the phonenumber.L To correct a digit, press {k/C}.2 {C}3 When you finish talking, press{ic} or place the handset on thebase unit or charger.Using the speakerphone1 Dial the phone number and press{s}.L Speak alternately with the otherparty.2 When you finish talking, press{ic}.Note:L For best performance, use thespeakerphone in a quiet environment.L To switch back to the receiver, press{C}.Adjusting the receiver or speakervolumePress {^} or {V} repeatedly whiletalking.Making a call using the redial listThe last 10 phone numbers dialled arestored in the redial list (each 24 digitsmax.).1 {>} (R)2 {V}/{^}: Select the desired phonenumber.3 {C}Erasing a number in the redial list1 {>} (R)2 {V}/{^}: Select the desired phonenumber. i {j/OK} 2 times3 {V}/{^}: “Yes” i {j/OK} i{ic}Pause (for PBX/long distance serviceusers)A pause is sometimes required whenmaking calls using a PBX or longdistance service. When storing a callingcard access number and/or PIN in thephonebook, a pause is also needed(page 16).Example: If you need to dial the lineaccess number “0” when making outsidecalls with a PBX:1 {0} i {T/P}2 Dial the phone number. i {C}Note:L A 3 second pause is inserted eachtime {T/P} is pressed. Repeat asneeded to create longer pauses.Answering calls1 Lift the handset and press {C} or{s} when the unit rings.L You can also answer the call bypressing any dial key from {0} to{9}, {*}, or {#}. (Any keyanswer feature)2 When you finish talking, press{ic} or place the handset on thebase unit or charger.Auto talkYou can answer calls simply by lifting thehandset off the base unit or charger. Youdo not need to press {C}. To turn thisfeature on, see page 18.Adjusting the handset ringer volumePress {^} or {V} repeatedly to select thedesired volume while the handset isringing for an incoming call.TG2511_2521CX(e-e).book Page 13 Thursday, March 11, 2010 10:34 AM