Answering System26unauthorised parties from listening toyour messages remotely.Important:L In order to operate the answeringsystem remotely, you must first set aremote access code.1 {j/OK}2 {V}/{^}: “Answer System” i{j/OK}3 {V}/{^}: “Settings” i {j/OK}4 {V}/{^}: “Remote Code” i{j/OK}5 To turn on remote operation, enterthe desired 3-digit remote accesscode.6 {j/OK} i {ic}Deactivating remote operationPress {*} in step 5 on “Remote accesscode”, page 25.L The entered remote access code isdeleted.Using the answering systemremotely1 Dial your phone number from atouch-tone phone.2 After the greeting message starts,enter your remote access code.L The unit announces the number ofnew messages.3 Follow the voice guidance promptsas necessary or control the unitusing remote commands (page 26).4 When finished, hang up.Note:L You can also leave a message just asany outside caller can. After thegreeting message starts, press {*} toskip the greeting message and recordyour message after the beep.Voice guidanceDuring remote operation, the unit’s voiceguidance starts and prompts you topress {1} to perform a specificoperation, or press {2} to listen to moreavailable operations.Note:L If you do not press any dial keys within10 seconds after a voice guidanceprompt, the unit disconnects your call.Remote commandsYou can press dial keys to accesscertain answering system functionswithout waiting for the voice guidance toprompt you.*1 If pressed within the first 5 seconds ofa message, the previous message isplayed.Key Operation{1} Repeat message(during playback) *1{2} Skip message(during playback){4} Play new messages{5} Play all messages{6} Play greeting message{7} Record greeting message{9} Stop recordingStop playback{0} Turn answering system off{*}{4} Erase currently playingmessage{*}{5} Erase all messages{*}{6} Reset to a pre-recordedgreeting message (duringgreeting messageplayback){*}{#} End remote operation(or hang up)TG2511_2521CX(e-e).book Page 26 Thursday, March 11, 2010 10:34 AM