Making/answering calls, intercomProblem Cause/solutionis flashing. R The handset is too far from the base unit. Move closer.R The base unit’s AC adaptor is not properly connected.Reconnect AC adaptor to the base unit.R The handset is not registered to the base unit. Register it(page 38).R Activating one touch eco mode reduces the range of the baseunit in standby mode. If required, turn eco mode off (page 15).Noise is heard, sound cutsin and out.R You are using the handset or base unit in an area with highelectrical interference. Re-position the base unit and use thehandset away from sources of interference.R Move closer to the base unit.R If you use a DSL/ADSL service, we recommend connecting aDSL/ADSL filter between the base unit and the telephone linejack. Contact your DSL/ADSL provider for details.The handset does not ring. R The ringer volume is turned off. Adjust ringer volume(page 16).The base unit does notring.R The ringer volume is turned off. Adjust ringer volume(page 21).Caller IDProblem Cause/solutionCaller information is notdisplayed.R You must subscribe to a Caller ID service. Contact yourservice provider/telephone company for details.R If your unit is connected to any additional telephoneequipment, remove and plug the unit directly into the wall jack.R If you use a DSL/ADSL service, we recommend connecting aDSL/ADSL filter between the base unit and the telephone linejack. Contact your DSL/ADSL provider for details.R Other telephone equipment may be interfering with this unit.Disconnect the other equipment and try again.Caller information is slowto display.R Depending on your service provider/telephone company, theunit may display the caller’s information at the 2nd ring orlater. Set the first ring to “Off” (page 21).R Move closer to the base unit.The name stored in thephonebook is not fullydisplayed while an outsidecall is being received.R Edit the phonebook entry name to fit in 1 line of text (page 18).Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333 37Useful Information