Panasonic KX-TG3711BX Operating Instructions Manual

Also see for KX-TG3721BX: Service manual

Programming33Changing the handset nameEach handset can be given a customizedname (“Bob”, “Kitchen”, etc.). This is usefulwhen you make intercom calls betweenhandsets. You can also select whether or notthe handset name is displayed in standbymode. The default setting is “No”. If you select“Yes” without entering any handset name,“Handset 1” to “Handset 2” is displayed.1 {MENU}y1z42 Enter the desired name (max. 10characters; see the character table, page24, 47).L If not required, go to step 3.3 {OK}4 {r}: Select the desired setting. s {OK} 2times5 {OFF}Incoming call barring (Caller IDsubscribers only)This feature allows the unit to reject calls fromspecified phone numbers that you do not wantto answer such as junk calls.When a call is received, the unit does not ringwhile the caller is being identified. If the phonenumber matches an entry in the call barred list,the unit sends out a busy tone to the caller, andthen disconnects the call.Important:L When the unit receives a call from a numberthat is stored in the call barred list, the call islogged in the caller list (page 34) with $after the call is disconnected.Storing unwanted callersYou can store up to 30 phone numbers in thecall barred list.Important:L You must store the phone number with anarea code in the call barred list.■ From the caller list:1 {3} CID2 {r}: Select the entry to be barred.3 {SAVE}4 {r}: “Caller Barred” s {OK}5 {r}: “Yes” s {OK}6 {OFF}■ By entering phone numbers:1 {MENU}y217 s {ADD}2 Enter the phone number (24 digitsmax.).L To erase a digit, press {CLEAR}.3 {OK} s {OFF}Viewing/editing/erasing bar callnumbers1 {MENU}y2172 {r}: Select the desired entry.L To exit, press {OFF}.3 To edit a number:{EDIT} s Edit the phone number. s{OK} s {OFF}To erase a number:{ERASE} s {r}: “Yes” s {OK} s{OFF}Note:L When editing, press the desired dial key toadd, {CLEAR} to erase.TG37xx38xxBX(e).book Page 33 Wednesday, June 8, 2011 2:08 PM