Programming26Special programmingAlarmAn alarm sounds at the set time for 3minutes once or daily. Alarm can be setfor each handset.Important:L Set the date and time beforehand(page 14).1 8 i {#}{7}{2}{0}2 {V}/{^}: Select the desired alarmoption. i M3 Enter the desired date and month.i M4 Set the desired time. i M5 {V}/{^}: Select the desired alarmtone. i ML We recommend selecting adifferent ringer tone from the oneused for outside calls.6 M i {ic}L When the alarm is set, E isdisplayed.Note:L When you select Arabic or Persian asthe display language, enter thedesired month and date.L To stop the alarm, press any dial keyor place the handset on the base unitor charger.L When the handset is in use, the alarmwill not sound until the handset is instandby mode.Changing the handset nameEach handset can be given acustomised name (“Bob”, “Kitchen”,etc.). This is useful when you makeintercom calls between handsets. Youcan also select whether or not thehandset name is displayed in standbymode. The default setting is “Off”. Ifyou select “On” without entering anyhandset name, “Handset 1” to“Handset 6” is displayed.1 8 i {#}{1}{0}{4}2 Enter the desired name (max. 10characters; page 39).L If not required, go to step 3.3 M4 {V}/{^}: Select the desired setting.i M 2 times5 {ic}Storing an area code to bedeleted automaticallyIn some situations, phone numbersstored automatically in the caller list(page 29) will include area codes. If youdo not want to dial the area code whenmaking calls from the caller list, you canstore the area code which you want theunit to delete automatically.Example: You have stored the areacode “123”. If you make a call from thecaller list to the phone number “123-456-7890”, the unit dials “456-7890”.1 8 i {#}{2}{5}{5}2 Enter an area code (5 digits max.).i M i {ic}“Off”Turns alarm off. Go to step 6.“Once”An alarm sounds once at the settime.“Daily”An alarm sounds daily at the set time.Go to step 4.TG5511_6511_6521BX(e).book Page 26 Tuesday, June 8, 2010 9:17 AM