Answering System38Answering systemsettingsNumber of rings before the unitanswers a callYou can change the number of times thephone rings “Csengetések száma” beforethe unit answers a call. You can select 2 to 7rings, or “Automata”.The default setting is “4 csengetés”.“Automata”: The unit’s answering systemanswers at the end of the 2nd ring when newmessages have been recorded, or at the endof the 5th ring when there are no newmessages. If you call your phone fromoutside to listen to new messages (37. oldal),you know that there are no new messageswhen the phone rings for the 3rd time. Youcan then hang up without being charged forthe call.1 8 i {#}{2}{1}{1}2 {V}/{^}: Select the desired setting. iM i {ic}For voice mail service subscribersTo receive voice mail and use answeringsystem properly, please note the following:L To use the voice mail service (39. oldal)provided by your service provider/telephone company rather than the unit’sanswering system, turn off the answeringsystem (34. oldal).L To use this unit’s answering system ratherthan the voice mail service provided byyour service provider/telephone company,please contact your service provider/telephone company to deactivate yourvoice mail service.If your service provider/telephonecompany cannot do this:– Set this unit’s “Csengetések száma”setting so that this unit’s answeringsystem answers calls before the voicemail service of your serviceprovider/telephone company does. It isnecessary to check the number of ringsrequired to activate the voice mailservice provided by your serviceprovider/telephone company beforechanging this setting.– Change the number of rings of the voicemail service so that the answeringsystem can answer the call first. To doso, contact your serviceprovider/telephone company.Caller’s recording timeYou can change the maximum messagerecording time allowed for each caller. Thedefault setting is “3 perc”.1 8 i {#}{3}{0}{5}2 {V}/{^}: Select the desired setting. iM i {ic}Selecting “Greeting Only”You can select “Csak üdv.” which sets theunit to announce a greeting message tocallers but not record messages.Select “Csak üdv.” in step 2 on „Caller’srecording time”, 38. oldal.Megjegyzés:L When you select “Csak üdv.”:– If you do not record your own message,the unit will play the pre-recordedgreeting-only message asking callers tocall again later.– If you use your own message, recordthe greeting-only message askingcallers to call again later (35. oldal).TG6511-6521HG(e-hg).book Page 38 Friday, January 22, 2010 2:49 PM