Panasonic KX-TG6611PD Operating Instructions Manual

Programming29Changing the unit’s regionsetting/Resetting the base unit1 8(1362 {r}: Select the desired country. s M3 {r}: “Tak” (“IGEN”) s M s {ic}Megjegyzés:L The following items will be deleted or reset totheir default settings:– SMS settings (24. oldal)– Answering system settings(KX-TG6621, 23. oldal)– Time Adjustment– Base unit ringer volume(KX-TG6621)– Base unit transmission power– Privacy mode– Base unit PIN– Dial mode– Recall/flash time– All SMS messages– Caller list– Voice mail messages– Call restrictL The following items will be retained:– Display language– Date and time– Handset name– Repeater mode– Recordings, including your greeting messageand caller messages (KX-TG6621)– Call screening (KX-TG6621)– Call barred listL According to your country selection in step 2, theanswering system announcement languagechanges as follows (KX-TG6621):L After changing the unit’s region setting/resetting the base unit, _ is displayed on thehandset momentarily. This is normal and thehandset can be used once w is displayed.Registering a unitOperating additional unitsAdditional handsetsUp to 6 handsets can be registered to the base unit.Fontos:L The additional handset model recommended foruse with this unit is noted on 4. oldal. If anotherhandset model is used, certain operations(handset settings, base unit settings, etc.) maynot be available.Registering a handset to the baseunitThe supplied handset and base unit are pre-registered. If for some reason the handset is notregistered to the base unit (for example, _ isdisplayed even when the handset is near the baseunit), re-register the handset.1 Handset:8(13)2 Base unit:Proceed with the operation for your model.■ KX-TG6611/KX-TG6612Press and hold {x} for about 5 seconds.(No registration tone)■ KX-TG6621Press and hold {x} for about 5 seconds,until the registration tone sounds.L If all registered handsets start ringing,press {x} again to stop, then repeat thisstep.L The next step must be completed within 90seconds.3 Handset:M s Wait until “Bázis PIN” is displayed.s Enter the base unit PIN (default: “0000”).s ML If you forget your PIN, contact anauthorised service centre.L When the handset has been registeredsuccessfully, w is displayed.Megjegyzés:L While registering, “Bázisállomásregisztráció” is displayed on all registeredhandsets.TG6611_6621PD(e-hg).book Page 29 Monday, February 14, 2011 10:53 AM