Panasonic KX-TG6611PD Operating Instructions Manual

Answering System39*1 If pressed within the first 5 seconds ofa message, the previous message is played.*2 This command is not included in voiceguidance.*3 To repeat the voice guidance, press 9 again.Turning on the answering systemremotelyIf the answering system is off, you can turn it onremotely.1 Dial your phone number from a touch-tonephone.2 Let the phone ring 10 times.L A long beep is heard.3 Enter your remote access code within 10seconds after the long beep.L The greeting message is played back.L You can either hang up, or enter yourremote access code again and beginremote operation (38. oldal).Answering system settingsNumber of rings before the unitanswers a callYou can change the number of times the phonerings “Csengetések száma” before the unitanswers a call. You can select 2 to 7 rings, or“Automata”.The default setting is “4 csengetés”.“Automata”: The unit’s answering systemanswers at the end of the 2nd ring when newmessages have been recorded, or at the end of the5th ring when there are no new messages. If youcall your phone from outside to listen to newmessages (38. oldal), you know that there are nonew messages when the phone rings for the 3rdtime. You can then hang up without being chargedfor the call.1 8(2112 {r}: Select the desired setting. s M s{ic}For voice mail service subscribersTo receive voice mail and use answering systemproperly, please note the following:L To use the voice mail service (40. oldal) providedby your service provider/telephone companyrather than the unit’s answering system, turn offthe answering system (36. oldal).L To use this unit’s answering system rather thanthe voice mail service provided by your serviceprovider/telephone company, please contactyour service provider/telephone company todeactivate your voice mail service.If your service provider/telephone companycannot do this:– Set this unit’s “Csengetések száma”setting so that this unit’s answering systemanswers calls before the voice mail service ofyour service provider/telephone companydoes. It is necessary to check the number ofrings required to activate the voice mailservice provided by your serviceprovider/telephone company beforechanging this setting.– Change the number of rings of the voice mailservice so that the answering system cananswer the call first. To do so, contact yourservice provider/telephone company.Caller’s recording timeYou can change the maximum message recordingtime allowed for each caller. The default setting is“3 perc”.1 8(3)52 {r}: Select the desired setting. s M s{ic}Selecting “Csak üdv.”You can select “Csak üdv.” which sets the unit toannounce a greeting message to callers but notrecord messages.Select “Csak üdv.” in step 2 on „Caller’srecording time”, 39. oldal.Megjegyzés:L When you select “Csak üdv.”:– If you do not record your own message, theunit will play the pre-recorded greeting-onlymessage asking callers to call again later.– If you use your own message, record thegreeting-only message asking callers to callagain later (36. oldal).*6 Reset to a pre-recorded greetingmessage (during greeting messageplayback)*2*( End remote operation (or hang up)*2Key OperationTG6611_6621PD(e-hg).book Page 39 Monday, February 14, 2011 10:53 AM